CONAIR CD89W3N (01) PDF Document

When using the CONAIR CD89W3N, basic safety precautions should always be followed to reduce the risk of burns, electrocution, fire, or injury:

1. Always unplug the appliance immediately after using.

2. Do not use the curling iron while bathing or in the shower.

3. Do not place or store the appliance where it can fall or be pulled into a tub or sink.

4. Do not place in, or drop into water or other liquids.

5. If the appliance falls into water, unplug it immediately and do not reach into the water.

6. This appliance should never be left unattended when plugged in.

7. Close supervision is necessary when the appliance is used by, on, or near children or individuals with certain disabilities.

8. Use the curling iron only for its intended use as described in the manual. Do not use attachments not recommended by the manufacturer.

9. Never operate the appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged, or dropped into water. Return it to an authorized service center for examination and repair.

10. Keep the cord away from heated surfaces. Do not pull, twist, or wrap the cord around the appliance, even during storage.

11. Never block the air openings or place the iron on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep openings free of lint, hair, and other debris.

12. Never use the device while sleeping.

13. Do not use outdoors or operate where aerosol products are being used or where oxygen is being administered.

14. Do not use an extension cord with this appliance.

15. The curling iron is hot when in use. Do not let heated surfaces touch eyes or skin. Do not touch the hot surfaces; use the handles or cool tip.

16. Do not place the heated curling iron directly on any surface or on the appliance power cord while it is hot or plugged in.

17. Do not use a voltage converter with this product.

The CONAIR CD89W3N features 25 variable temperature settings to provide styling versatility for all hair types. Use the following guide to determine the best setting for your hair:

If you have fine hair, a low temperature will provide the best results. If you have thick, wavy, or hard-to-curl hair, keep the heat setting on high. You can vary the temperature according to your particular needs.

Hair should be clean and completely dry before using the curling iron. Section hair evenly and comb each section before winding. For best results, use a light styling product before blow-drying.

1. Start curling with a hair section that is 1 inch wide and no more than 1/2 inch thick.

2. Open the spoon and place the curling iron midway up the hair section, then spread hair evenly between the spoon and the barrel.

3. Gently slide the curling iron down to the hair ends. To avoid crimped ends, ensure they are securely wound under the spoon in the direction of the desired curl.

4. Place the spoon above the hair strand for curls rolled under; place the spoon under the hair strand for a flip style.

5. Wind the hair up as far as you want it curled, being careful not to let the iron touch the scalp. Hold for 8-12 seconds, depending on the length and texture of your hair.

6. For tighter, bouncier curls, roll less hair. For looser, free-flowing curls, roll more hair.

7. To remove the curling iron, unwind the hair and press the handle to allow the curl to slide out. To set the curl, do not comb or brush the hair until it has cooled.

To achieve faster styling results, the CONAIR CD89W3N features a unique, optional Turbo Heat burst. By pressing the Turbo button, the iron delivers up to 20 degrees Celsius/36 degrees Fahrenheit more heat for maximum styling performance in difficult spots.

Yes. If you fail to turn the unit off, the CONAIR CD89W3N will shut itself off automatically within 60 minutes at 60 Hz, or 72 minutes at 50 Hz.

The CONAIR CD89W3N has dual voltage capability. It will automatically adjust to the proper voltage (120/240V) when plugged into an outlet. You must use an adapter plug with the correct configuration for the specific outlet prior to use.

The CONAIR CD89W3N is engineered with a Uniform Heat Recovery System that maintains the curling iron at constant temperatures. There is a constant surge of power to ensure heat is continuously delivered for optimal styling results. This system ensures every strand of hair is set with the same level of heat for a perfect finish.

The curling iron is virtually maintenance-free and no lubrication is needed. Follow these steps for cleaning and maintenance:

1. Keep all vents and openings clear of dirt and dust.

2. If cleaning is necessary, disconnect the curling iron from the power source, let it cool, and wipe the exterior with a cloth.

3. If any abnormal condition occurs, unplug the iron, allow it to cool, and return it for repair to an authorized service center only. Do not attempt repairs yourself.

4. Never allow the power supply cord to be pulled or twisted. Never wrap the cord around the appliance, as this will cause the cord to rupture and short circuit at the point of entry. Inspect the cord frequently for damage.

When not in use, the CONAIR CD89W3N should be disconnected, allowed to cool, and stored in a safe, dry location out of reach of children. Do not jerk or strain the cord at plug connections. Do not wrap the line cord around the appliance; instead, allow the cord to hang or lie loose and straight at the point of entry into the iron.

The CONAIR CD89W3N has a polarized plug where one blade is wider than the other. This plug will fit into a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

Due to the high heat temperatures reached by the CONAIR CD89W3N, this styler should not be used on hair extensions.