Free English CISCO SG110-24HP (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD CISCO SG110-24HP (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I rack-mount the CISCO SG110-24HP?
To optionally rack-mount your CISCO SG110-24HP, follow these steps:
1. Using a screwdriver, attach one of the supplied rack-mount brackets to the side of the switch with the provided screws.
2. Attach the second rack-mount bracket to the opposite side of the switch.
3. With the brackets installed on the switch, you can now mount the unit in a standard equipment rack.
What are the safety instructions for rack-mounting the CISCO SG110-24HP?
Please observe the following safety instructions when rack-mounting the CISCO SG110-24HP:
A) Elevated Operating Ambient – If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow – Installation of the equipment in the rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.
C) Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to uneven mechanical loading.
D) Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing these concerns.
E) Reliable Earthing – Reliable Earthing of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch current (e.g. use of power strips).”
How do I power on the CISCO SG110-24HP?
To power on the switch, connect the supplied power cord to the power input on the back of the CISCO SG110-24HP. Plug the other end of the power cord into a standard electrical outlet.
How do I attach devices to the CISCO SG110-24HP?
To attach devices such as computers, servers, printers, or wireless access points to your CISCO SG110-24HP, simply connect them to any of the available Ethernet ports on the front of the switch using standard network cables.
What is the operating temperature range for the CISCO SG110-24HP?
The ambient temperature range for the CISCO SG110-24HP is 32° to 113° F (0° to 45° C).
How do I use the Physical Cable Diagnostics on the CISCO SG110-24HP?
The CISCO SG110-24HP has built-in diagnostics for cables which can detect cable issues upon connection to a port. For best detection accuracy, please use a minimum cable length of 10 meters (~30 feet).
Cable Diagnostic Output:
• A physical cable fault enables the port’s amber LED continuously.
• Loop detection will enable periodic amber LED blinking on the port.
Procedure:
Step 1: Ensure that the switch is powered on.
Step 2: With the suspected cable connected to the switch, look at the pertinent interface’s LED outputs. A solid amber LED indicates a cable fault or an open end. A blinking amber LED indicates a loop.
CLICK HERE TO DOWNLOAD CISCO SG110-24HP (01) PDF DOCUMENT