CASIO XJ-S400WN (01) PDF Document

To connect your CASIO XJ-S400WN projector for a wired LAN connection, use a LAN cable to connect the projector to a network device, such as a router. This allows the projector to be controlled from an external device via its LAN port.

Yes, the CASIO XJ-S400WN projector supports control using a computer web browser.

Yes, the CASIO XJ-S400WN projector supports the PJLink Class1 standard formulated by the Japan Business Machine and Information System Industries Association (JBMIA).

The following table shows the PJLink input switching instruction and input switching query parameters and their corresponding input sources for the CASIO XJ-S400WN projector.

The CASIO XJ-S400WN projector has the following PJLink limitations:

• Image only mute is not supported by the AV mute instruction and AV mute state query.

• The cover open error and filter error are not supported by the error state query.

• A projector name query returns the projector name specified on the Web Service Page.

• A manufacturer name query returns CASIO.

• A device name query returns XJ-F21XN / XJ-F211WN / XJ-UT312WN / XJ-UT352WN / XJ-S400UN / XJ-S400WN.

The password used for the PJLink connection authentication process is the same as the Setup page password on the Web Service Page. You can configure the projector to enable or disable authentication through the Projector’s Setup Menu.

To access the setting, navigate to [Network Settings] -> [Network Settings] -> [PJLINK Authentication].

• Enable: PJLink connection authentication is enabled. (This is the initial default setting).

• Disable: PJLink connection authentication is disabled.

To use a Crestron controller, you must configure the controller’s IP address and other settings on the CASIO XJ-S400WN projector. These settings are found on the Crestron Control page, which appears when you click [Other Settings] on the Setup page of the Web Service Page.

Enter the following information:

• IP address: Specifies the controller IP address.

• IP ID: Specifies the controller IP ID.

• Port: Specifies the port number being used (Always 41794).

After entering the information, click the [Save changes] button to apply the new settings.

Yes, the CASIO XJ-S400WN projector supports the AMX controller and Device Discovery. The commands used for control are standard PJLink commands.

You can configure the CASIO XJ-S400WN projector to enable or disable power on via wired LAN from the standby state. Use the [Network Settings]-[Remote On] option in the projector’s Setup Menu.

• Enable: Power on is enabled.

• Disable: Power on is disabled. (Initial default)

Note: Initializing the network settings through the Setup Menu will reset this option to “Disabled”. If you operate the projector using a wired LAN setting, ensure you change this setting back to “Enabled” after initialization.

When turning on the CASIO XJ-S400WN projector from its standby state via a wired LAN, be aware of the following restrictions:

• The wired LAN connection will be disconnected for about one minute after the projector is turned on. During this period, the projector will not respond to ping commands, and you cannot operate it using PJLink, Crestron, or AMX commands.

• If your projector obtains an IP address automatically from a DHCP server, it might be assigned a different IP address each time it powers on. If you require a consistent IP address, change the network settings to use a fixed IP address.