CAMDEN CM-1005 (01) PDF DOCUMENT

(1) Heavy duty diecast surface box

(1) Heavy duty 1/4″ thick aluminum faceplate

(2) Tamper proof screws and driver

(1) Color coded 18 AWG soldered leads

(1) Weatherproof gasket

(1) Lock ring

Note: Mortise Cylinder Sold Separately

The CAMDEN CM-1005 key switch is designed to work with most 1″, 1 1/8″ or 1 1/4″ mortise cylinders, and with different types of cams.

One or two switches may be installed, either momentary and/or maintained (alternating on/off).

1. The switch (es) provided may be mounted in either the left or the right hole on the back of the faceplate. Thread the octagonal nut (spacer ring) on to the bushing (stem) of the switch before placing the switch in the hole.

2. Insert the switch up through the bottom of the desired hole. Secure the switch in place by screwing the round threaded washer onto the top of the switch.

3. Fit the mortise cylinder through the front of the face plate being sure to align the grooves on the sides of the cylinder with the corresponding “retainers” on the back of the face plate.

4. Push firmly on the cylinder, until it snaps into place, lying flush in the front of the face plate (aluminum models only). Note that some cylinders may appear not to fit in the face plate. If the grooves on the side of the cylinder are irregular and do not align with the retainers on the back of the faceplate, use a metal file to file down the retainers slightly.

Note – do not file the retainers off completely as they prevent the cylinder from spinning in the face plate.

5. Thread the brass cylinder lock ring onto the back of the cylinder, and tighten in place.

6. Turn the key in the cylinder, and ensure the cam hits the top of the switch squarely in the center. Adjust the switch in the slotted hole until the cam hits in the center. It does not affect operation of the cam if the cylinder rests against the switch, so long as the switch is not fully depressed until activated by a turn of the key. If the cam does not depress the switch, or blocks the switch from resetting, raise or lower the octagon nut located under the switch, as needed. Extra spacers are provided and may be used as required.

7. Once the electrical connections are completed, attach the faceplate assembly to the surface box using the supplied tamperproof or stainless steel Phillips screws. For outdoor use, place the rubber weather proofing gasket behind the face plate prior to securing to the surface box.

Certain operations may require different cams. For this application use a standard cam with a minimum length (L) of 0.550″ and a maximum length (L) of 0.785″.

The CAMDEN CM-1005 uses a Type 1 SPST Momentary (N.C. or Normally Closed) switch. The wiring color codes are as follows:

When the switch is pressed the current pole will change to the opposite state until released.

Key Switches may be ordered with optional LEDs. These LEDs are designed for DC Voltage only.

For Single Color LEDs (RED, GREEN, or AMBER):

12 VDC: Connect the RED wire to positive (+) and the BLACK wire to negative (-). A 560 ohms resistor is integrated with the LED.

24 VDC: Connect the RED wire to positive (+) and the BLACK wire to negative (-). A 1.5 k ohms resistor is required in the circuit.

For Bi-Colour LEDs:

12 VDC: Connect to a SPDT switch. The common BLACK wire connects to negative (-). The RED wire is for the red color and the GREEN wire is for the green color, connected to the switch terminals. A 560 ohms resistor is integrated.

24 VDC: Connect to a SPDT switch. The common BLACK wire connects to negative (-). The RED wire is for the red color and the GREEN wire is for the green color, connected to the switch terminals. A 1.5 k ohms resistor is required.