BOSCH RFKF-FBS-A (01) PDF MANUAL

BOSCH RFKF-FBS-A (01) PDF SUMMARY:

How do you use the panic alarm feature?

Pressing both the arm and disarm buttons in unison for at least 1 sec transmits a panic alarm. This feature is intended to be used indoors only.

How do you arm the system using the RFKF-TBS-A?

To arm the system, simply press and hold the arm button for at least one sec.

How do you disarm the system using the RFKF-TBS-A?

To disarm the system, simply press and hold the disarm button for at least one sec.

What does the red LED light indicate?

The red LED lights up after pressing either button for at least 1 sec indicating that the arm or disarm signal has been transmitted to the panel.

How do you use the panic alarm feature on the RFKF-FBS-A?

Pressing both the arm and disarm buttons in unison for at least 1 sec transmits a panic alarm. This feature is intended to be used indoors only.

How do you arm the system using the RFKF-FBS-A?

To arm the system, simply press and hold the arm button for at least one sec.

How do you disarm the system using the RFKF-FBS-A?

To disarm the system, simply press and hold the disarm button for at least one sec.

What does the red LED light indicate?

The red LED lights up after pressing either button for at least 1 sec indicating that the arm or disarm signal has been transmitted to the panel.

How is the arming/disarming sequence confirmed?

Confirmation of the arming/disarming sequence is dependant on the supporting control panel programming. Verify your control panel documentation for detailed information regarding Remote Warning.

What does the Remote Warning parameter do?

When enabled, the Remote Warning parameter pulses the alarm bell once (2-sec ON, then OFF) when the assigned area is remotely armed, and twice (2-sec ON, 2-sec OFF, 2-sec ON, then 2-sec OFF) when the area is remotely disarmed. This parameter also applies to keyswitch arming and disarming.