BLAUPUNKT MPS 1662 C35 (01) PDF Document

Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your installation carefully to avoid compromising the performance reliability of the system. Consult an authorized Blaupunkt dealer for installation or preparation. Read the manual carefully before operating the device for the first time.

Ensure to follow the below safety notes during installation and wiring connection:

• Disconnect the negative terminal of the battery. Refer to the safety notes of the vehicle manufacturer.

• Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.

• Ensure the cross section of the cable is no less than 2.5mm² if the positive and negative cables are too long.

• Incorrect installation may result in malfunction of the device or the car sound system.

• Select a dry and well-ventilated location to install the device.

• The device must not be installed in overly exposed locations such on the rear shelf, rear seat etc.

• The installation location must be suitable for screw holes and have stable ground support.

• Use the supplied power extension cable to connect to the positive battery terminal.

• Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.

• The control of the device should be a two-channel control, either via the preamplifier output of the car sound system.

• A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels.

The system should be installed with the tweeters placed high, such as on the dashboard or A-pillars, and the woofers installed lower, typically in the front door panels. Both the tweeter and woofer for each channel (left and right) are connected to the corresponding crossover, which is then connected to the audio device (head unit).

The woofer included with the BLAUPUNKT MPS 1662 C35 has the following specifications:

• Normal Output Power (RMS): 60W

• Max. Power Handling: 150W

• Voice Coil Diameter: 35.55mm

• Impedance: 4 ohms

• Frequency Response: 62Hz-20,000Hz

• Sensitivity: 88dB

• Mounting Depth: 67mm

• Diameter Hole: 140mm

The tweeter included with the BLAUPUNKT MPS 1662 C35 has the following specifications:

• Voice Coil: 28.3mm

• Normal Output Power (RMS): 15W

• Max. Power Handling: 30W

If you encounter a problem with your BLAUPUNKT MPS 1662 C35 speakers, please refer to the table below for possible solutions. If the problem persists, consult a Blaupunkt authorized dealer.

Do not dispose of your old unit in the household trash! Use the return and collection systems available to dispose of the old device.

In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products.

This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on an as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.