AUDIOVOX ELECTRONICS PURSUIT PRO-9556 (01) PDF Document

The AUDIOVOX ELECTRONICS PURSUIT PRO-9556 includes the following features:

2 Three Button Programmable RF Transmitters

Three Channel Receiver (capable of accepting 4 transmitters)

Keyless Entry Outputs (+) and (-)

On-Board Start Relay

On-Board Accessory Relay

On-Board Ignition 1 Relay

On-Board Ignition 2 Relay

Ignition 2 Relay Selectable On or Off During Cranking

On-Board Parking Light Relay

Ignition 3 / Shock By-Pass / GM VAT Output (relay required)

Tach Signal Learning Circuit

Two ( + ) and Two ( – ) Safety Shutdown Circuits

Alarm By-Pass Output

Accessory Outputs (Pulse Before & After Start, During Crank & After Shut Down)

Selectable Steady or Flashing Parking Lights for Run Indication

Selectable 5, 10, 15, 20 Minute Run Time

Selectable 1 Sec., 3.5 Sec., or 1 Sec./Dbl 1 Sec. Door Lock Output Pulse

Car Finder Mode

The Lock button on the transmitter is used to lock the vehicle’s doors, and the Unlock button is used to unlock the vehicle’s doors. To lock or unlock the doors, simply press and release the desired function button one time. As a visual indication, the parking lights will flash once when the doors are locked and twice when the doors are unlocked.

To access the car finder mode, while within range of your car, simply press and hold either the lock or unlock button of your transmitter for three seconds. The parking lights will begin to flash, making your vehicle more visible. The lights will stop automatically after 30 seconds.

If you wish to turn off the car finder mode prior to the expiration of the 30-second timer, press and release either the lock or unlock button of your transmitter one time.

The unit will not start the vehicle if any one of the following situations exists:

The vehicle’s hood lid is opened.

The gear shift selector is not in Park.

The brake pedal is depressed.

The safety control switch is in the Off position.

To start the vehicle, press and release the Key/Trunk button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, or 20-minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting determined by your installation center.

When you arrive at the vehicle, turn the ignition key to the ON position (not the spring-loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now under its own power.

The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions:

Press and release the Key/Trunk button on the keychain transmitter two times within 2 seconds.

Depress the brake pedal.

Open the vehicle’s hood.

Place the unit in the safety control disabled mode.

The Push-Button LED control switch allows you to temporarily disable the remote starting function. This is recommended whenever the vehicle is being serviced. To place the system in service mode:

1) With the system disarmed/unlocked, and the ignition switch off, Press and Hold the PRLED on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED begins to flash two short flashes followed by one long flash and continues this pattern until returned to normal mode of operation.

This puts the unit into the R/S Override mode indicating that the remote start is in the service mode and will not start from RF or any other input.

To Exit R/S Override Mode:

1) With the system disarmed, Press and Hold the PRLED on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED turns off indicating that the R/S unit is fully functional one again.

The following chart displays functions that can be set by the installer: