ASUS PRIME A620-PLUS WIFI6 (01) PDF Document

To safely install components on the ASUS PRIME A620-PLUS WIFI6, follow these precautions: Unplug the power cord from the wall socket before touching any component. Before handling components, use a grounded wrist strap or touch a safely grounded object or a metal object, such as the power supply case, to avoid damaging them due to static electricity. Hold components by the edges to avoid touching the integrated circuits. Whenever you uninstall any component, place it on a grounded antistatic pad or in the bag that came with the component. Before you install or remove any component, ensure that the power supply is switched off or the power cord is detached from the power supply.

Before installing, unplug all power cables. The ASUS PRIME A620-PLUS WIFI6 uses the AM5 socket, which has a specific pinout design. Ensure you use a CPU designed for the AM5 socket. The CPU fits in only one correct orientation. Do not force the CPU into the socket to prevent bending the connectors. Apply the Thermal Interface Material to the CPU cooling system and CPU before you install the cooling system if necessary.

To install a DIMM on the ASUS PRIME A620-PLUS WIFI6, first ensure the retention clips at the ends of the DIMM slot are pushed outward. Align the notch on the memory module with the key on the slot and insert the module firmly into the slot until it clicks into place and the clip locks automatically. For removal, push the retention clips outward to release the module and lift it out.

You can install varying memory sizes in the DIMM channels of the ASUS PRIME A620-PLUS WIFI6. The system maps the total size of the lower-sized channel for the dual-channel configuration, and any excess memory from the higher-sized channel is mapped for single-channel operation. Always install the DIMMS with the same CAS Latency for optimum compatibility.

To clear the RTC RAM on the ASUS PRIME A620-PLUS WIFI6: 1. Turn OFF the computer and unplug the power cord. 2. Short-circuit the CLRTC pin 1-2 with a metal object or jumper cap for about 5-10 seconds. 3. Plug the power cord and turn ON the computer. 4. Hold down the Delete key during the boot process and enter BIOS setup to re-enter data.

If the ASUS PRIME A620-PLUS WIFI6 fails to boot after changing any BIOS setting, try to clear the CMOS and reset the motherboard to the default value. You can also load default settings by selecting the Load Optimized Defaults item under the Exit menu or by pressing the F5 hotkey.

To update the BIOS on the ASUS PRIME A620-PLUS WIFI6: 1. Insert the USB flash disk containing the latest BIOS file into a USB port. 2. Enter the Advanced Mode of the BIOS setup program, go to the Tool menu, select ASUS EZ Flash 3 Utility, and press Enter. 3. Use the Left arrow key to switch to the Drive field. 4. Use the Up/Down arrow keys to select the USB flash disk and press Enter. 5. Press the Right arrow key to switch to the Folder field. 6. Use the Up/Down arrow keys to find the BIOS file, press Enter to begin the update, and reboot the system when done.

If the BIOS on the ASUS PRIME A620-PLUS WIFI6 becomes corrupted, the ASUS CrashFree BIOS 3 utility can restore it. Download the latest BIOS for this model, rename it using the BIOSRenamer.exe utility, the specified BIOS CAP filename, or to asus.cap, and save it to a USB flash drive. Plug the drive into the system and turn it on. The utility will automatically detect the file and enter the ASUS EZ Flash 3 interface to restore the BIOS.

The ASUS PRIME A620-PLUS WIFI6 has shared bandwidth between PCIEX16_2, PCIEX16_3, and M.2_2. When configured with an M.2 device in M.2_2, the slot will run at x2 mode if either PCIEX16_2 or PCIEX16_3 is occupied. Refer to the manual’s configuration table for specific lane mappings.

The ASUS PRIME A620-PLUS WIFI6 rear panel includes: 1 x USB 5Gbps port (Type-C), 2 x USB 5Gbps ports (Type-A), and 3 x USB 2.0 ports (Type-A).

The ASUS PRIME A620-PLUS WIFI6 features 1 x 4-pin CPU Fan header, 1 x 4-pin CPU OPT Fan header, 1 x 4-pin AIO Pump header, and 3 x 4-pin Chassis Fan headers.

For the ASUS PRIME A620-PLUS WIFI6 Ethernet port: Activity Link LED: OFF means no link, ORANGE means linked, and BLINKING indicates data activity. Speed LED: OFF indicates a 10 Mbps connection, ORANGE indicates a 100 Mbps connection, and GREEN indicates a 1 Gbps connection.

To install the Wi-Fi moving antenna on the ASUS PRIME A620-PLUS WIFI6, simply connect the bundled antenna connector to the Wi-Fi ports located at the back of the motherboard chassis and ensure it is securely tightened.

The ASUS PRIME A620-PLUS WIFI6 supports AMD RAIDXpert2 technology for both PCIe and SATA RAID 0, 1, and 10 configurations.

Connect the front panel audio I/O module cable to the header labeled F_AUDIO on the ASUS PRIME A620-PLUS WIFI6. This header supports HD Audio compliant pin definitions.

The System Panel header on the ASUS PRIME A620-PLUS WIFI6 supports the following chassis-mounted functions: System Power LED (PLED), Storage Device Activity LED (HDD_LED), System Warning Speaker (SPEAKER), Power Button/Soft-off Button (PWRSW), Reset button (RESET), and Chassis intrusion header (CHASSIS).

The ASUS PRIME A620-PLUS WIFI6 requires an 8-pin +12V power connector in addition to the 24-pin main power connector. It is recommended to use a PSU with higher power output when configuring the system with many power-consuming devices to ensure stability.

The ASUS PRIME A620-PLUS WIFI6 features a Realtek 7.1 Surround Sound High Definition Audio CODEC, which includes audio shielding, premium audio capacitors, and dedicated audio PCB layers. It supports jack-detection, multi-streaming, front panel jack-retasking, and playback up to 24-Bit/192 kHz.

Yes, the ASUS PRIME A620-PLUS WIFI6 features Addressable Gen 2 headers that allow you to connect individually addressable RGB WS2812B LED strips or WS2812B based LED strips (5V/Data/Ground). Ensure the 5V connector is correctly aligned with the header.

The ASUS PRIME A620-PLUS WIFI6 provides internal headers for this: 1 x USB 5Gbps connector (supports Type-C), 1 x USB 5Gbps header supporting 2 additional USB 5Gbps ports, and 2 x USB 2.0 headers supporting 4 additional USB 2.0 ports.

The reset button header on the ASUS PRIME A620-PLUS WIFI6 is set to Reset by default, but you can assign a different function to it in the BIOS settings.

Yes, the ASUS PRIME A620-PLUS WIFI6 has an SPI TPM header (14-1pin) to support a Trusted Platform Module system for enhanced network security and data protection.

The ASUS PRIME A620-PLUS WIFI6 includes 2 x M.2 slots (Key M) and 4 x SATA 6Gb/s ports.

Connect the COM port module cable to the COM Port header on the ASUS PRIME A620-PLUS WIFI6, then install the module into a slot opening on the system chassis.

The ASUS PRIME A620-PLUS WIFI6 is an ATX form factor motherboard measuring 12 inches by 9.6 inches (30.5 cm x 24.4 cm).

To enter BIOS Setup on the ASUS PRIME A620-PLUS WIFI6 at startup, press the Delete or F2 key during the Power-On Self Test (POST).

Yes, the BIOS Setup on the ASUS PRIME A620-PLUS WIFI6 offers EZ Mode and Advanced Mode. You can change modes from the Setup Mode option in the Boot menu or by pressing the F7 hotkey.

If a BIOS update process fails on the ASUS PRIME A620-PLUS WIFI6, you can attempt to recover the BIOS using the ASUS CrashFree BIOS 3 utility by using a USB flash drive containing the latest BIOS file.

On the ASUS PRIME A620-PLUS WIFI6, all fan headers (CPU_FAN, CPU_OPT, CHA_FAN1, CHA_FAN2, CHA_FAN3, AIO_PUMP) support a maximum current of 1A and a maximum power of 12W. Most default to Q-Fan Controlled mode, while AIO_PUMP defaults to Full-Speed.

Yes, the button battery on the ASUS PRIME A620-PLUS WIFI6 must be kept out of reach of children. Swallowing can lead to chemical burns, perforation of soft tissue, and death, with severe burns occurring within 2 hours of ingestion.

The ASUS PRIME A620-PLUS WIFI6 includes Wi-Fi 6 (802.11 a/b/g/n/ac/ax) supporting 2.4/5GHz bands and Bluetooth v5.3.

The ASUS PRIME A620-PLUS WIFI6 supports AMD Socket AM5 for AMD Ryzen 7000 Series and 8000 Series Desktop Processors.

Yes, the ASUS PRIME A620-PLUS WIFI6 supports 4 x DIMM slots, max. 192GB, DDR5 ECC and Non-ECC, Un-buffered memory.

Connect the speaker to the 4-pin SPEAKER header within the System Panel header block on the ASUS PRIME A620-PLUS WIFI6.

The USB Type-C port on the ASUS PRIME A620-PLUS WIFI6 provides a maximum power delivery output of 5V/3A.

Connect a chassis-mounted intrusion detection sensor or switch to the 2-pin CHASSIS header on the ASUS PRIME A620-PLUS WIFI6. The switch sends a high-level signal to the header if a chassis component is removed or replaced.

The ASUS PRIME A620-PLUS WIFI6 features 1 x DisplayPort and 1 x HDMI port. The DisplayPort supports up to 8K at 60Hz and the HDMI port supports up to 4K at 60Hz.

The ASUS PRIME A620-PLUS WIFI6 provides 4 x SATA ports with 6Gb/s data transfer speeds.

First, verify that the addressable RGB LED strip is connected in the correct orientation and that the 5V connector is aligned with the 5V header on the ASUS PRIME A620-PLUS WIFI6. Also, ensure the system is powered on, as the lights will only illuminate when the system is active.

Yes, the ASUS PRIME A620-PLUS WIFI6 includes audio shielding as part of its audio features.

The M.2_1 slot on the ASUS PRIME A620-PLUS WIFI6 supports PCIe 4.0 x4 mode for both AMD Ryzen 7000 and 8000 Series Processors.

Yes, do not short-circuit the CLRTC pins on the ASUS PRIME A620-PLUS WIFI6 except when clearing the RTC RAM, as doing so otherwise will cause system boot failure. If the jump does not work, remove the onboard button cell battery and short the pins again.

Yes, the ASUS PRIME A620-PLUS WIFI6 rear panel includes 1 x PS/2 keyboard/mouse combo port.

No, the ASUS PRIME A620-PLUS WIFI6 BIOS update utility supports USB flash disks formatted in FAT 32/16 only with a single partition.

The S/PDIF Out header on the ASUS PRIME A620-PLUS WIFI6 allows you to connect the Sony/Philips Digital Interface (S/PDIF) Out module.

You can check the supported CPU list for the ASUS PRIME A620-PLUS WIFI6 on the manufacturer website.

The Clear CMOS header on the ASUS PRIME A620-PLUS WIFI6 allows you to clear the Real Time Clock (RTC) RAM in the CMOS, which contains the date, time, system passwords, and system setup parameters.

Yes, the ASUS PRIME A620-PLUS WIFI6 features a dedicated 4-pin AIO Pump header for cooling systems.

The ASUS PRIME A620-PLUS WIFI6 should only be used in environments with ambient temperatures between 10°C and 35°C.

You cannot install a DDR4 memory module in the ASUS PRIME A620-PLUS WIFI6 because the DDR5 memory sockets have a different notch design to prevent incorrect module installation.

Yes, for BIOS recovery on the ASUS PRIME A620-PLUS WIFI6, you can use the BIOSRenamer.exe application to automatically rename the BIOS file.

Always hold the ASUS PRIME A620-PLUS WIFI6 components by their edges, use a grounded wrist strap, and touch a grounded metal surface before handling them to avoid static electricity damage.