ASTI SOUND+SLEEP MINI ASM1014 (01) PDF Document

To get started with your ASTI SOUND+SLEEP MINI ASM1014, follow these steps:

1. Unpack the box to ensure you have the unit, power adapter, power cable, and audio cable.

2. Connect the power: Locate the power connector on the bottom of the unit. Push the non-USB end of the power cable into the connector, then plug the USB-A end into the supplied power adapter and connect it to a wall outlet.

3. Turn on the unit: Press the power button. The unit will start playing sound in a second or two.

4. Select a sound: Press the select category button to choose a sound category, then press the select sound button to pick the desired sound within that category.

5. Adjust volume: Use the volume up and down buttons to set your preferred volume.

The ASTI SOUND+SLEEP MINI ASM1014 offers four flexible power options:

1. Use four AA batteries installed in the bottom of the unit.

2. Use the supplied power adapter and power cable.

3. Use both batteries and the power adapter for battery backed up AC power.

4. Use the supplied power cable only by connecting it to a powered USB connector on a device such as a desktop or notebook PC.

To use the sleep timer, press the timer button to select the desired interval: 30, 60, or 90 minutes. Both lights lit indicate 90 minutes. When no timer lights are on, the ASTI SOUND+SLEEP MINI ASM1014 will play continuously until you turn it off.

When you plug an audio cable into the 3.5mm audio input jack on the upper right side of the ASTI SOUND+SLEEP MINI ASM1014, the unit automatically switches to external audio mode. This allows you to listen to audio from a smartphone, PC, or other devices. To set this up properly: 1) Turn the ASTI SOUND+SLEEP MINI ASM1014 volume down. 2) Connect one end of the audio cable to your sound source. 3) Connect the other end of the audio cable to the audio input jack on the ASTI SOUND+SLEEP MINI ASM1014. 4) Turn on the 6 dB boost if desired by using the adaptive button. 5) Adjust the volume to your desired listening level.

To set the lights to stay on continuously, follow these steps:

1. Start with the ASTI SOUND+SLEEP MINI ASM1014 turned off.

2. Press and hold the timer button.

3. Press and release the power button.

4. As soon as the lights come on, release the timer button.

To perform a factory reset on your ASTI SOUND+SLEEP MINI ASM1014, do the following:

1. Turn the unit off and remove the batteries if they are installed.

2. Connect the power adapter and power cable.

3. Turn the unit on.

4. Wait a few seconds, then press and hold the power button down again until the SoundStory lights flash (approximately two seconds).

5. Release the power button.

If your ASTI SOUND+SLEEP MINI ASM1014 appears to be on but there is no sound, the volume may be set too low. Simply press or hold the volume up button to increase the volume level.

First, verify the power connection on the bottom of the ASTI SOUND+SLEEP MINI ASM1014 and at the power adapter to ensure both ends are firmly seated. If that does not work, try a different un-switched wall outlet. If you are using batteries, ensure they are not dead or too weak, or if no batteries are installed, try inserting new ones. When using batteries, always try powering on again with the power cable as well, as it is optional.

A flashing adaptive light on your ASTI SOUND+SLEEP MINI ASM1014 indicates that the batteries are dead. You should remove the power cable, remove the dead batteries, and insert new batteries.