ARCTIC KING ARU07B3AWW (01) PDF Document

Before connecting the ARCTIC KING ARU07B3AWW appliance to the power source, let the appliance stand for 2-3 hours.

The ARCTIC KING ARU07B3AWW upright freezer should run 4 hours before loading fresh or frozen foods.

After the ARCTIC KING ARU07B3AWW upright freezer is powered on, when the temperature control knob rotates clockwise, the temperature in the freezer will gradually decrease, and when it rotates counterclockwise, the temperature will gradually increase.

When the knob is adjusted within the scope of “COOLING”, the box is a refrigerator, when the knob is adjusted within the scope of “FREEZING”, the box is frozen.

The “OFF” file indicates stop.

When selecting the refrigeration function on the ARCTIC KING ARU07B3AWW, it is recommended that the temperature control knob be set in the middle of the refrigeration icon area. During refrigeration, there may be water drops on the inner wall of the liner, which is normal and the refrigerator can be used normally.

When the ARCTIC KING ARU07B3AWW machine is in refrigeration mode (including when the freezer mode is adjusted to the refrigeration mode), there will be condensation water on the top of the box. It is necessary to adjust the position of the glass shelf. Place any one of the four glass shelves in the topmost position of the box to avoid condensation water dropping on the food. The small space at the top is recommended for storing packaged food.

When the ARCTIC KING ARU07B3AWW machine is in freezing mode for a long time, the inner wall of the cabinet will frost, and the frost will thicken with time, which will affect its cooling effect. In this case, please cut off the power in time for manual defrosting, clean the inner wall and then power on to continue using the machine.

When the freezing mode is switched to the refrigeration mode of the ARCTIC KING ARU07B3AWW, the temperature inside the cabinet will rise. In order to avoid a large amount of defrosting water flowing out of the box and damaging the floor and other items, please cut off the power for manual defrosting before putting food in.

To ensure energy efficiency with the ARCTIC KING ARU07B3AWW appliance:

• The appliance should be located in the coolest area of the room, away from heat producing appliances or heating ducts, and out of the direct sunlight.
• Let hot food cool down to room temperature before storing them in the appliance. Overloading the appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This cuts down on frost build-up.
• Storage areas should not be lined with aluminum foil, wax paper, or paper towels. Liners may interfere with cold air circulation, making the appliance less efficient.
• Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time, and close the door as soon as possible.

To adjust the leveling feet on the ARCTIC KING ARU07B3AWW:

1. Turn the feet clockwise to raise the freezer.
2. Turn the feet counterclockwise to lower the freezer.
3. Adjust based on the previous procedures until the unit is leveled.

The tools required to reverse the door on the ARCTIC KING ARU07B3AWW are:

Step 1) Remove all food from the ARCTIC KING ARU07B3AWW unit. Fix the door with tape (see below pictures).

Step 2) Dismantle hinge cap, the upper right hinge cover, the fitting screws and remove the upper right hinge. Please keep the door in a vertical position during the process to prevent it from damaging.

The door reversal procedure for the ARCTIC KING ARU07B3AWW involves the following steps:

1. Remove all food from the unit. Fix the door with tape.
2. Dismantle the hinge cap, the upper right hinge cover, the fitting screws and remove the upper right hinge. Keep the door in a vertical position to prevent damage.
3. Remove the door.
4. Dismantle the door stopper, and install it on the opposite side.
5. Dismantle the lower hinge and adjustable leg.
6. Install the lower hinge on the lower left side of the cabinet and the adjustable leg on the right.
7. Mount the door on the lower hinge, vertically, and make sure the door gasket is tight. Take out the spare upper left hinge and hinge cover (included in the accessory bag), then install the upper left hinge using the fitting screws. Finally install the hinge cover, and the hinge hole cap on the upper right side.

Important considerations for door reversal:

• At least 2 persons are recommended to execute this procedure.
• Keep the appliance partially inclined during this procedure to avoid damage to the refrigeration system.
• Transport inclination should NOT be more than 45 degrees.

For cleaning the ARCTIC KING ARU07B3AWW upright freezer:

• Dusts behind the freezer and on the ground should be regularly cleaned to improve the cooling effect and help with energy saving.
• The interior of the unit should be cleaned regularly to avoid odor. Soft towels or sponge dipped in water and non-corrosive neutral detergents are recommended for cleaning. Open the door for natural air drying before putting the power on.
• Do not use hard brushes, clean steel balls, abrasives, and organic solvents (such as alcohol, acetone solutions, banana oil, etc.), boiling water, acid or alkaline products to clean your freezer as this may damage the interior and exterior surfaces.
• Do not rinse thoroughly with water (flush) so as not to affect the electrical insulation properties. Use a dry cloth when cleaning temperature control.
• Always unplug the freezer before proceeding with defrosting and/or cleaning.

Your ARCTIC KING ARU07B3AWW freezer is to be manually defrosted by following these steps:

• Disconnect the plug from the wall socket, open the door and remove all the food and store in a cool place.
• To remove the frost, use a plastic scraper or let the warm temperature rise naturally until the ice has melted. Then wipe away the remaining ice and water. Do not use any mechanical devices to accelerate the defrost process. Be careful not to damage the refrigerant circuit.

Regarding service interruption and moving the ARCTIC KING ARU07B3AWW:

• In case of power failure foods can be preserved for a few hours even in summer time. It is recommended to reduce the frequency of door openings and not to add fresh foods.
• Unplug the freezer when left unused for a long period of time or for cleaning. Keep the door open to avoid developing odors or mold.
• Do not turn the unit upside down or shake it. The carrying inclination cannot be greater than 45 degrees.
• When moving the unit do not hold it by the door or hinge.
• It is recommended continuous operation once the freezer is installed. Please do not stop the freezer unnecessarily so as not to affect the unit’s service life.

If the ARCTIC KING ARU07B3AWW unit is not operating, check the following:

• Not plugged in.
• The circuit breaker tripped or has a blown fuse.
• The freezer temperature control is set at “OFF”.

If there are odors inside the ARCTIC KING ARU07B3AWW upright freezer, check the following:

• Odorous foods should be thoroughly wrapped.
• Foods are rotten.
• Unit should be cleaned.

Long-term operation of the compressor in the ARCTIC KING ARU07B3AWW upright freezer may be caused by:

• The room temperature is hotter than normal.
• A large amount of food has been added to the freezer.
• The door is opened too often.
• The door is not entirely closed.
• The temperature control is not set correctly.
• The door gasket does not seal properly.
• The freezer does not have the correct clearances.
• The freezer has recently been disconnected for a period of time. Four hours are required for the freezer to cool down completely.

If the freezer door on the ARCTIC KING ARU07B3AWW does not properly close, check the following:

• The freezer is not leveled.
• The gasket is dirty.

If the ARCTIC KING ARU07B3AWW upright freezer is making a loud noise, check the following:

• The freezer is not leveled correctly.
• Check if accessories are correctly positioned and do not vibrate.

After refrigeration, there will be a pressure difference between the inside and outside of the ARCTIC KING ARU07B3AWW freezer, creating temporary resistance when opening the door. This is a normal physical phenomenon.

Regarding heat/condensation on the ARCTIC KING ARU07B3AWW upright freezer enclosure:

• The freezer enclosure may emit heat during operation, especially in summer, caused by the radiation of the condenser, and this is a normal phenomenon.
• Condensation can be detected on the exterior surface and door seals of the freezer when the ambient humidity is high; this is a normal phenomenon, and the condensation can be wiped away with a dry towel.

For airflow sound, buzz, and clatter in the ARCTIC KING ARU07B3AWW upright freezer:

• Refrigerants circulating in the tubes will produce sounds and grunts. This is normal and does not affect the cooling effect.
• The running compressor will buzz especially when starting up or shutting down.
• The solenoid valve or electric switch valve can clatter, which is a normal phenomenon and does not affect the operation.

Warnings related to the disposal of the ARCTIC KING ARU07B3AWW upright freezer:

• The freezer’s refrigerant and cyclopentane foam materials are combustible, and a discarded freezer should be isolated from fire sources. Please remit your unit to a qualified professional recycling company.
• Risk of entrapment. Please remove the door of the freezer and leave the shelves in to avoid accidents.
• This marking indicates that this product should not be disposed with regular household waste. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly and promote the sustainable reuse of material resources. To return your used device, please call local authorities or contact the retailer where the product was purchased. They will ensure this product is safely recycled.