APUTURE CF7 (01) PDF Document

To attach the CF7 Fresnel:

Insert it into the ProLock Mount and rotate the Pro-Lock Handle clockwise until it locks.

To detach the CF7 Fresnel:

Rotate the Pro-Lock Handle counterclockwise to the open position and remove the Fresnel.

To attach the Barn Doors:

1. Slide them onto the front lip of the CF7 Fresnel.

2. Press the quick-release locking latch to secure them in place.

To detach the Barn Doors:

1. Release the latch.

2. Slide them off the lip of the Fresnel.

Secure the safety chain to the designated mounting hole on the CF7 Barn Doors.

1. Open the scrim lock on the CF7 Barn Doors.

2. Place the 7-inch scrim into the circular holder.

3. Slide the scrim lock to secure it in place.

Ensure the scrim is fully seated and locked before use.

The photometric data varies by distance and beam angle:

At 1m (3.28ft):

• At 15° beam angle: 236700 lux / 21989 fc

• At 40° beam angle: 53900 lux / 5007 fc

At 3m (9.84ft):

• At 15° beam angle: 23260 lux / 2161 fc

• At 40° beam angle: 6380 lux / 593fc

At 5m (16.4ft):

• At 15° beam angle: 8220 lux / 764 fc

• At 40° beam angle: 2367 lux / 220 fc

When using this modifier, the following basic safety precautions should always be followed:

1. Read and understand all instructions before use.

2. Close supervision is necessary when any fixture is used by or near children. Do not leave the fixture unattended while in use.

3. Use caution, as burns can occur from touching hot surfaces.

4. Allow the fixture to cool completely before storing.

5. To reduce the risk of injury, always install or disassemble the fixture properly.

6. Do not use accessory attachments not recommended by the manufacturer, as they may increase the risk of fire, electric shock, or injury.

7. Do not place the fixture near flammable objects.

8. Only use a dry microfiber cloth to clean the product.

9. This product is RoHS certified. Please operate it in full compliance with applicable standards.

10. The information in this manual is based on thorough, controlled testing procedures. Specifications are subject to change without prior notice.

WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a different circuit than the receiver is connected to.

• Consult the dealer or an experienced radio/TV technician for help.

RF Warning Statement:

This device has been evaluated to meet general RF exposure requirements.