Free English ANKO JLR-79336 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD ANKO JLR-79336 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I turn on the ANKO JLR-79336?
Press the on/off button to enable the device. The LED light will turn to red color.
How do I change drum kits on the ANKO JLR-79336?
Press the drum team button to select 5 different types of drum kits.
How do I play and control the rhythm on the ANKO JLR-79336?
Press the rhythm button to play, it built 10 sets of accompaniment. When the rhythm is playing, the button is used to change the rhythm. You can press enable/stop to start or pause the rhythm.
How do I adjust the tempo on the ANKO JLR-79336?
Press the tempo+ button to increase the speed of rhythms and demo songs. Press the tempo- button to decrease the speed of rhythms and demo songs.
How do I use the recording function on the ANKO JLR-79336?
Press the record button to record a song. It can record about 700 drums. It will emit two beeps when recording is full.
How do I play the recorded song on the ANKO JLR-79336?
Press the R_play button to play the record drum song.
How do I play demo songs on the ANKO JLR-79336?
Press the demo song button to play a demo song. It built in 10 songs. Press this button again to stop the song, then press this button to go to the next song.
How do I adjust the volume on the ANKO JLR-79336?
Press the volume+ button to increase the volume. Press the volume- button to decrease the volume. Press the volume+ and volume- at the same time will return the volume to default setting.
How do I charge the ANKO JLR-79336?
The drum set is powered via an integrated rechargeable battery. The battery cannot be removed or replaced. Upon initial use, the battery should be charged fully to ensure optimal performance and battery life. Charge the device with the included USB charging cable. Plug the USB-C end of the charging cable into the DC charging port and the USB-A into a suitable USB port on your computer or a USB wall charger with DC5V. The led indicator will turn red while charging. Once fully charged, the red led will turn to green. Charging time is approximately 2-3 hours.
How do I connect the ANKO JLR-79336 via Bluetooth?
1. Turn on your drum set.
2. Choose “ANKO JLR-79336” on your Bluetooth device to connect the drum set.
3. When successfully paired and connected, a beep will issue from the unit.
4. The LED indicator will turn to green.
5. You only can use your Bluetooth device to control music volume.
Note: Only one Bluetooth device can be connected at one time. Should your device become unpaired or you are not able to connect it, repeat the above.
What are the drum map components for the ANKO JLR-79336?
1. Crash cymbal
2. High Tom
3. Ride cymbal
4. Hi-Hat
5. Snare Drum
6. Mid Tom
7. Low/Floor Tom
CLICK HERE TO DOWNLOAD ANKO JLR-79336 (01) PDF DOCUMENT