AMAZON BASICS B07D3DY7ZL (01) PDF Document

To reduce the risk of fire, electric shock, and injury when using the AMAZON BASICS B07D3DY7ZL, follow these precautions:

Do not attempt to repair the product yourself. In case of malfunction, repairs are to be conducted by qualified personnel only.

To avoid overheating, do not cover the product.

Do not use this product in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.

During cleaning or operation, do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.

Children of less than 3 years should be kept away unless continuously supervised.

Children aged from 3 years and less than 8 years shall only switch on/off the product provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the product or perform user maintenance.

The product must not be located immediately below a socket outlet.

Do not use this product with a programmer, timer, separate remote-control system or any other device that switches the product on automatically, since a fire risk exists if the product is covered or positioned incorrectly.

Do not use this product in the immediate surroundings of a bath, a shower or a swimming pool.

Do not use if there are visible signs of damage to the product.

Use this product on a horizontal and stable surface.

Before connecting the product to the power supply, check that the power supply voltage and current rating corresponds with the power supply details shown on the product rating label.

Never use a damaged product! Disconnect the product from the electrical outlet and contact your retailer if it is damaged.

Do not operate the product with wet hands or while standing on a wet floor. Do not touch the power plug with wet hands.

Disconnect the product from the power supply when it is not in use.

Do not use this product in areas where dangerous and flammable materials, like petrol, paint thinner, paints and lacquers are used.

The AMAZON BASICS B07D3DY7ZL is only suitable for well insulated spaces or occasional use.

This product is intended for temporary heating or ventilating residential rooms.

This product is intended for household use only. It is not intended for commercial use.

This product is intended to be used in dry indoor areas only.

No liability will be accepted for damages resulting from improper use or non-compliance with these instructions.

The AMAZON BASICS B07D3DY7ZL includes the following parts:

1. Power indicator

2. Front grille

3. Air intake

4. Tip-over switch

5. Power cord with plug

6. Thermostat knob

7. Mode knob

Keep any packaging materials away from children as they are a potential source of danger, such as suffocation.

Check the product for transport damages.

Clean the product before first use.

Before connecting the product to the power supply, check that the power supply voltage and current rating corresponds with the power supply details shown on the product rating label.

The power indicator stays on as long as the power plug is connected to the power source.

Step 1. Connect the power plug to an appropriate power outlet.

Step 2. Turn the thermostat knob clockwise all the way to the high position (+).

Step 3. Set the mode knob to the desired setting:

Dot symbol: The product is off.

Fan symbol: Fan only mode.

Single flame symbol: Low heat mode.

Double flame symbol: High heat mode.

Step 1. Switch on the product.

Step 2. When the desired temperature is reached, turn the thermostat knob counter-clockwise until the unit turns off.

Step 3. The thermostat control will now maintain the temperature by turning the product on and off automatically.

The AMAZON BASICS B07D3DY7ZL is designed to automatically shut-off when tipped over. When returned to the proper upright position, the product will resume normal operation.

To prevent electric shock, always unplug the AMAZON BASICS B07D3DY7ZL before cleaning. During cleaning, do not immerse the electrical parts of the product in water or other liquids. Never hold the product under running water.

To clean, wipe with a soft, slightly moist cloth.

Dry the product after cleaning.

Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.

Store the product in a cool and dry place away from children and pets, ideally in its original packaging.

Avoid any vibrations and shocks during maintenance and storage.

If the AMAZON BASICS B07D3DY7ZL does not operate, check the following troubleshooting solutions:

Check if the power plug is connected to the power outlet. Check if the power outlet works.

Check if the product is switched on.

Unplug the product and let it cool for 30 minutes.

Ensure the product is in the proper upright position.

For UK models: If the fuse in the plug is blown, use a flat screwdriver to open the fuse compartment cover. Remove the fuse and replace it with the same type (13 A, BS1362). Refit the cover.

The AMAZON BASICS B07D3DY7ZL utilizes a single stage heat output with no room temperature control. However, it is equipped with a mechanical thermostat for room temperature control (YES).

Other control options such as presence detection, open window detection, distance control, adaptive start control, working time limitation, or black bulb sensors are NOT included (NO).

Before switching on, make sure the voltage of your electricity supply is the same as indicated on the rating plate. The AMAZON BASICS B07D3DY7ZL is designed to operate on 220-240 V. The wires in the power cable are coloured in accordance with the following code:

A. Green/Yellow = Earth

B. Blue = Neutral

C. Brown = Live

The appliance is protected by a 13 A approved (BS 1362) fuse. If the colours of the wires do not correspond with the markings on the terminals of your plug, proceed as follows:

The Green/Yellow wire must be connected to the terminal marked E, or by the earth symbol, or coloured Green or Green/Yellow.

The Blue wire must be connected to the terminal marked N or coloured Black.

The Brown wire must be connected to the terminal marked L or coloured Red.

The outer sheath of the cable should be firmly held by the clamp.