ALLITY AWC-200-15WMS (01) PDF Document

Step 1. Remove the USB-C cable from its packaging.

Step 2. Connect one end of the USB-C cable to the mains adapter, and the other end to the USB-C connector on the charger.

Step 3. Place the smartphone near the charging slot marked on the charger. The magnet will automatically snap into place and accurately position your smartphone in the most efficient slot for charging.

The adjustable stand lets you choose the angle at which you want to place your smartphone.

Note: The ALLITY AWC-200-15WMS charger is designed primarily for use with an iPhone with MagSafe technology. The charger can be used with other devices, but the magnetic function will not work.

Please follow these safety rules when using your ALLITY AWC-200-15WMS:

• Read the instructions carefully and keep them for future reference. Ignoring these instructions can be dangerous or illegal.

• A wireless charger is a device that allows electronic devices such as smartphones to be charged wirelessly. Use of the device beyond its intended purpose is illegal and harmful to the environment.

• Use the device only for its intended purpose.

• Do not use the product in areas where the use of electronic equipment is prohibited, or where it may cause interference or other hazards.

• Do not expose the unit to water or other liquids. The unit should not be used in areas of high humidity. This can adversely affect the operation and life of electronic components.

• The device should not be operated by persons (including children) with reduced mobility or mental capacity, or by persons who are inexperienced in the use of electronic equipment. They should only use it under the supervision of persons responsible for their safety.

• Do not use the device if it shows signs of damage or if you suspect that it is not working properly.

If your ALLITY AWC-200-15WMS is connected but not charging, please perform the following checks:

• Check that the power source to which the charger is connected is not faulty.

• Check that the connection cable (USB-C) is not damaged.

• Check that the device whose battery is being charged is not damaged.

If the inductive charging feature is not working on your ALLITY AWC-200-15WMS, please check the following:

• Check that the maximum inductive charging distance has not been exceeded (e.g. by using additional cases on the device being charged).

• Check that the technical parameters of the power source used are compatible with those of the charger.

It is normal for the ALLITY AWC-200-15WMS charger to heat up during use. Make sure that the device for which the battery is being charged is not using too much power. If the problem persists, contact your service provider.

Use only a soft, dry cloth to clean the ALLITY AWC-200-15WMS. Do not use strong acid or alkaline detergents.

The ALLITY AWC-200-15WMS is marked with the crossed-out wheeled bin symbol in accordance with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). Products marked with this symbol should not be recycled or disposed of with other household waste at the end of their working life. The user is obliged to dispose of waste electrical and electronic equipment by taking it to a designated point for the recycling of such hazardous waste. Proper recycling of waste electrical and electronic equipment has a positive impact on human health and the environment.