ABUS HOMETEC PRO CFS3100 (01) PDF Document

For the initial setup of your ABUS HomeTec Pro Bluetooth door lock drive, you will need a Bluetooth-enabled smartphone (Bluetooth 4.0 LE or higher), a currently supported iOS or Android software version, and the free ABUS HomeTec Pro app for iOS or Android.

The drive can be operated with either a smartphone (Bluetooth and the ABUS HomeTec Pro app) or with the ABUS HomeTec Pro CFS3100 finger scanner and other HomeTec Pro components.

The ABUS HomeTec Pro CFS3100 finger scanner serves as an alternative to using a smartphone. It is dust-proof and splash-proof (IP54 rating) and possesses extremely high UV resistance.

The printed manual may be outdated. You can find the current and complete version of the installation and operating instructions for the ABUS HomeTec Pro CFS3100 by visiting the ABUS website, searching for “CFS3100”, and navigating to the “Downloads” tab on the product page.

Select a suitable place to install the ABUS HomeTec Pro CFS3100 finger scanner outside your home, close to the door it controls and easily accessible to all users regardless of their height. Ensure you can scan your finger at a comfortable angle without overextending it.

Before installation, test the radio connection to your drive for the ABUS HomeTec Pro CFS3100 finger scanner.

Installation of the ABUS HomeTec Pro CFS3100 finger scanner should be carried out professionally and adapted to suit the widely differing characteristics of external walls. Depending on the surface, the finger scanner may also be affixed with an adhesive such as silicone in addition to screws.

Slide the protective flap of the ABUS HomeTec Pro CFS3100 finger scanner upwards when not in use so that the touch field remains protected from the weather such as rain, moisture, and dirt.

To guarantee proper function, it is recommended to perform updates in the app and software/firmware updates for the ABUS HomeTec Pro components in a timely manner. The app will provide information on this, and updates can also be performed in the component’s settings.

Do not use cleaning agents and microfibre cloths on the ABUS HomeTec Pro CFS3100 finger scanner.

To program the ABUS HomeTec Pro CFS3100 finger scanner, start by pressing the button “Add HomeTec Pro / component”.

It is imperative to keep the ABUS Keycard(s) in a secure place even after completing the setup for the ABUS HomeTec Pro CFS3100. You need the Keycard for software updates, if you lose your smartphone, and for proof of ownership for warranty claims and repair. Do not give the Keycard to third parties.

The technical specifications for the ABUS HomeTec Pro CFS3100 are:

The ABUS HomeTec Pro CFS3100 contains three LR6 1.5 V alkaline batteries. Keep batteries out of the reach of children, as they can be swallowed, causing serious harm. Always insert batteries with the correct polarity (+ and -). Empty batteries should be removed or replaced immediately. Do not mix different battery types or new and used batteries. Do not short-circuit the battery terminals. Avoid contact with leaking or damaged batteries, use protective gloves, and clean the battery compartment with a dry cloth. Do not dismantle, puncture, damage, short-circuit, heat, charge, or throw batteries into fire. Do not use or store the product in areas with temperatures below 0°C or above +40°C, and avoid prolonged direct sunlight exposure.

To replace the batteries in the ABUS HomeTec Pro CFS3100, remove all three batteries first, and then insert the three new batteries.