ZTE BLADE V7 LITE V0720 (01) PDF Document

The ZTE BLADE V7 LITE V0720 features the following components and keys:

• Top and Front: Headset jack, Front flash, Earpiece, Proximity & light sensor, Front camera, Touch screen, Back key, Home key, Menu key.
• Sides: Volume key, Power key, nano-SIM / microSDHC card slot.
• Back and Bottom: Back flash, Back camera, Fingerprint sensor, Microphone, Charging/micro-USB jack, Speaker.

When installing cards into the tray slot of the ZTE BLADE V7 LITE V0720, please note the following:

Slot 1: Only supports a nano-SIM card.

Slot 2: Supports a microSDHC card.

WARNING! To avoid damage to the phone, do not use any other kind of SIM cards, or any non-standard nano-SIM card cut from a SIM card. You can get a standard nano-SIM card from your service provider.

Your phone’s battery should have enough power for the phone to turn on, find a signal, and make a few calls, but you should fully charge the battery as soon as possible.

WARNING! Use only ZTE-approved chargers and cables. The use of unapproved accessories could damage your phone or cause the battery to explode.

CAUTION: Do not change the built-in rechargeable battery in your phone by yourself. The battery can only be changed by an authorised service provider.

If the screen freezes or takes too long to respond, try pressing and holding the Power key for about 10 seconds to power off the phone, then press the Power key to start.

Please observe the following safety information regarding the ZTE BLADE V7 LITE V0720:

• Don’t make or receive phone calls while driving. Never text while driving.
• Keep your phone at least 15 mm away from your ear or body while making calls.
• Small parts may cause choking.
• Your phone can produce a loud sound. To prevent possible hearing damage, do not listen at high volume levels for long periods.
• Avoid contact with anything magnetic.
• Keep away from pacemakers and other electronic medical devices.
• Turn off when asked to in hospitals and medical facilities.
• Turn off when told to on aircraft and at the airport.
• Turn off when near explosive materials or liquids.
• Don’t use at gas stations.
• Your phone may produce a bright or flashing light.
• Don’t dispose of your phone in fire.
• Avoid extreme temperatures.
• Avoid contact with liquids. Keep your phone dry.
• Do not attempt to disassemble your phone.
• Only use approved accessories.
• Don’t rely on your phone as a primary device for emergency communications.

The mobile device is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. The guidelines use a unit of measurement known as Specific Absorption Rate, or SAR.

The SAR limit for mobile devices is 2 W/kg and the highest SAR value for this device when tested is as follows:

• Head: 0.467 W/kg
• Body: 0.530 W/kg

As SAR is measured utilizing the device’s highest transmitting power, the actual SAR of this device while operating is typically below that indicated above.

When the crossed-out wheeled bin symbol is attached to the product, it means the product is covered by the European Directive 2012/19/EU. Please follow these guidelines for disposal:

1. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities.

2. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health.