Free English YAMAHA CD-S303 (02) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD YAMAHA CD-S303 (02) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I check the firmware version on my YAMAHA CD-S303?
Follow these steps to check the firmware version of the unit:
1. Turn on the unit.
2. If the USB indicator on the front panel is lit, press CD/USB to switch to Disc mode. If a CD has been placed on the disc tray, remove it.
3. Press and hold A/B on the remote control. The current firmware version appears on the information display of the front panel for about five seconds. Write down the version number.
What items are required to download the firmware for the YAMAHA CD-S303?
You must have the following items ready:
1. A USB flash drive that meets all of the following requirements:
• Supports the USB mass storage device class
• Formatted in FAT16 or FAT32 format
• No encryption applied
• No data stored on the device (empty)
2. A Computer that can be connected to the Internet.
How do I save the firmware data file to the USB flash drive for the YAMAHA CD-S303?
1. Download the firmware to update only if it is newer than that of the unit.
2. Decompress the downloaded file and save the firmware data file in a folder at the highest level of hierarchy (i.e., the root folder) of the USB flash drive.
Note: Do not change the file name when saving the firmware data file to the USB flash drive.
How do I operate the YAMAHA CD-S303 to update the firmware?
1. Press CD/USB to switch to USB mode.
2. Connect the USB flash drive to the USB jack on the front panel. “UNSUPPORT” appears on the information display of the front panel.
3. Press and hold the Pause button. “UPGRADE” appears on the information display of the front panel, and the unit starts updating its firmware. The updating process takes about 20 seconds to complete. When the process completes, the unit automatically restarts.
Notice: Do not turn off the power to the unit while updating. Turning off the power while updating the firmware may cause damage to the unit.
4. Press CD/USB to switch to Disc mode.
5. Press and hold A/B on the remote control. Make sure that the firmware version indicated on the display is the same as that of the downloaded firmware.
6. Turn off the unit and remove the USB flash drive.
What should I do if “UPGRADE” stays on the information display for one minute or longer on the YAMAHA CD-S303?
If “UPGRADE” stays on the display for one minute or longer, the update process might have failed. Follow these steps:
1. Turn off the unit and remove the USB flash drive.
2. Make sure that the following requirements are satisfied:
• The firmware data file has been saved in a folder at the highest level of hierarchy (i.e., the root folder) of the USB flash drive.
• The data file name of the firmware has not been changed.
3. Perform the operation from step 1 of “Updating the firmware” again.
CLICK HERE TO DOWNLOAD YAMAHA CD-S303 (02) PDF DOCUMENT