XIAOMI C300 DUAL MJSXJ22CM (01) PDF Document

The package for the XIAOMI C300 DUAL MJSXJ22CM includes the following items:

• Xiaomi Smart Camera C300 Dual

• Charging cable

• Wall mounting kit (base and screws)

• User manual

The XIAOMI C300 DUAL MJSXJ22CM has several key components:

• Lens

• Indicator light

• Microphone

• MicroSD card slot (revealed by tilting the lens upward)

• Speaker

• Reset button

• Power port

You can install the XIAOMI C300 DUAL MJSXJ22CM in two ways:

1. Placing on a flat surface: You can place the camera on any flat surface like a desk, dining table, or bookcase.

2. Mounting on a wall:

Step 1. Use the wall mounting base as a template to mark the positions for the holes on the wall.

Step 2. Drill two holes at the marked positions.

Step 3. Insert the plastic wall plugs into the holes.

Step 4. Place the wall mounting base so that the arrow is pointing up, align the holes, and then insert the screws and tighten them into the wall plugs with a screwdriver.

Step 5. Align the grooves on the bottom of the camera with the raised area on the wall mounting base and place it on. The camera is successfully mounted when you hear a click sound.

Note: When wall mounting, ensure the camera is installed securely.

Follow these steps to set up your XIAOMI C300 DUAL MJSXJ22CM:

Step 1. Install a MicroSD card:

Make sure the camera is unplugged. Adjust the camera lens upward until the MicroSD card slot is revealed. Insert the MicroSD card into the slot with the contact points facing down.

Step 2. Turn on the camera:

Connect the power cable to the camera’s power port. The camera will turn on automatically.

Step 3. Connect to the Mi Home/Xiaomi Home app:

This product works with the Mi Home/Xiaomi Home app. Scan the QR code in the manual or on the product base to download and install the app. Once the app is installed, open it, and follow the on-screen instructions to add the device.

To reset your XIAOMI C300 DUAL MJSXJ22CM to factory settings, use a pin or a similar tool to press and hold the reset button. The reset button is located near the power port.