WORX HYDROSHOT WG629E (02) PDF Document

**Voltage measured without workload. Initial battery voltage reaches maximum of 20 volts. Nominal voltage is 18 volts.

This tool is intended for cleaning and watering.

When attaching the short lance, align the two projections on the lance with the grooves of the power nozzle.

When attaching, rotate the nozzle left and right to make sure the nozzle is fully seated into position and gently pull it to make sure it is locked into position securely.

When attaching the extension lance to the power nozzle or the short lance to the extension lance, align the two projections on the lance with the grooves of the power nozzle.

After the hose is attached to the power nozzle, check the connection by gently pulling upon the hose. It should not be pulled off.

Yes. Besides the hose supplied, you can also connect the power nozzle to your own water hose with suitable connectors.

1. Remove the hose adaptor.

2. Attach the home garden hose with suitable connectors.

Note: When retightening the quick hose adapter, please tighten securely. Otherwise, it may not draw any water for proper operation.

Your power nozzle has two pressure modes. High pressure mode is suitable for removing strong stains, while low pressure mode applies to light duty and watering.

At the first use, you need to empty the air in the hose. Place the power nozzle below waist level (less than 1.5m/5ft) and set it at high pressure. Do not start working until the water goes up along the hose and sprays out. This could take up to 30 seconds or more depending on the fresh water source.

Choose a suitable nozzle pattern according to your work. Spray patterns 0, 15, 25, and 40 degrees are applicable for cleaning, and the spray pattern with the symbol is best suitable for watering.

Warning: Do not shift the nozzle pattern when the tool is powered on.

Warning: Do not connect the machine to a water supply which is turbid, muddy, or corrosive.

Note: For proper maintenance after using with sea water, the product should be rinsed by fresh water.

The soap bottle provides detergent suds for deeper cleaning of dirt. It is used in conjunction with the power nozzle or extension lance.

The brush is for cleaning cars, boats, motorcycles, etc. It is used in conjunction with the power nozzle or extension lance.

Remove the hose filter from the hose and get out the strainer. Rinse the parts with clean water before reassembling.

Before storage, completely drain all the water from the machine and hose.

Clean the moulded plastic housing of the machine using a soft brush and clean cloth. Do not use water, solvents or polishes.

Store in a secure and dry place out of the reach of children. Do not place other objects on the product.

Store the machine and the accessories in a frost-free place.

1. The liquid must not be directed towards equipment containing electrical components.

2. Remove or disconnect the battery pack after use and before carrying out user maintenance on the appliance.

3. The appliance shall not be left unattended while it is connected to the battery pack.

4. The appliance is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking.

5. Keep the appliance out of reach of children when it is energized.

a) Do not dismantle, open or shred cells or battery pack.

b) Do not short-circuit a battery pack. Do not store battery packs haphazardly in a box or drawer where they may short-circuit each other or be short-circuited by conductive materials.

c) Do not expose battery pack to heat or fire. Avoid storage in direct sunlight.

d) Do not subject battery pack to mechanical shock.

e) In the event of battery leaking, do not allow the liquid to come into contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

f) Seek medical advice immediately if a cell or battery pack has been swallowed.

g) Keep battery pack clean and dry.

h) Wipe the battery pack terminals with a clean dry cloth if they become dirty.

i) Battery pack needs to be charged before use. Always refer to the instructions and use the correct charging procedure.

j) Do not maintain battery pack on charge when not in use.

k) After extended periods of storage, it may be necessary to charge and discharge the battery pack several times to obtain maximum performance.

l) Battery pack gives its best performance when it is operated at normal room temperature (20°C ± 5°C).

m) When disposing of battery packs, keep battery packs of different electrochemical systems separate from each other.

n) Recharge only with the charger specified by WORX.

o) Do not use any battery pack which is not designed for use with the equipment.

p) Keep battery pack out of the reach of children.

q) Retain the original product literature for future reference.

r) Remove the battery from the equipment when not in use.

s) Dispose of properly.