WELLER WMRP (01) PDF DOCUMENT

The WELLER WMRP appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

Keep other persons well away from your workplace. The work area is out of bounds for children and unauthorized persons. Never allow other persons to touch the soldering tool or cable.

Use only original Weller soldering tips.

Protect yourself against electric shocks. The handles on soldering tools with an antistatic design are conductive.

Avoid touching earthed objects such as pipes, heaters, cookers and refrigerators.

Do not use the soldering tool in a damp or wet environment.

Never work on voltage-carrying parts.

The soldering tip becomes very hot during soldering work. There is a risk of burns from touching the tips. After the soldering process, the soldering tool and the workpiece holder are still hot.

Always place the soldering tool in the safety rest while not in use. Make sure the safety holder is stable.

Do not touch the hot soldering tips and keep them away from inflammable objects.

Only replace solder tips when cold.

There is a risk of burning through liquid solder. Protect yourself against solder splashes.

Wear appropriate protective clothing to protect yourself against burns. Protect your eyes by wearing eye protection.

When working with adhesives, special attention must be paid to the warning information provided by the adhesive manufacturer.

Only connect the vacuum and hot air at the designated points.

Covering the soldering iron or the safety holder poses a fire hazard.

Always keep objects well away from the soldering iron and safety holder.

Keep all combustible objects, liquids or gases well away from the hot soldering tool.

Do not place or leave the hot soldering or desoldering tip on the worktop or on plastic surfaces.

Avoid unintentional operation. Disconnect the soldering tool from the power supply while not in use.

Keep explosive and flammable objects well away from the device.

When not in use, units and tools should be stored in a dry, high or locked area out of the reach of children. Make sure that unused soldering tools are free of voltage and de-pressurised.

Do not use the cable for purposes other than those for which it is intended. Never carry the unit by the cable. Do not use the cable to pull the plug out of the socket. Protect the cable against heat, oil and sharp edges.

Use the soldering iron exclusively for the purpose indicated in the Operating Instructions of soldering and desoldering under the conditions specified here.

The soldering iron may only be used in combination with Weller Supply Units.

This device may only be used at room temperature and indoors. Protect against moisture and direct sunlight.

Before doing any work on the machine, pull the plug out of the socket. Leave the unit to cool down.

Check all connected cables and hoses on a regular basis. If power tools are damaged, they must be immediately removed from use.

Do not use blocked nozzles.

Repairs must always be referred to a Weller-trained specialist.

Use original replacement parts only.

Only replace the soldering tips when they are cold. The soldering tool must be left switched off in the safety rest for at least 3 minutes until the soldering tip has cooled down.

The WELLER WMRP soldering tool has an internal usage sensor which can be used to set an automatic switch-off function (Stand-by). The settings can be found in the station’s operating instructions.

Due to differing degrees of risk and potential hazards, several work steps may only be performed by trained experts.

The required equipotential bonding to the soldering tip can be established via the supply unit used. The connection options for an equipotential bonding cable are described in the operating instructions for the supply unit.

! (Exclamation mark in triangle): Caution!

SSS (Three wavy lines in triangle): Warning! Risk of burns

(Open book icon): Read the operating instructions!

(Hand in circle with ESD text): ESD-compatible design and ESD-compatible workstation

CE: CE mark of conformity

UK CA: British Conformity Mark