WELLER WMRP MS (01) PDF DOCUMENT

The WELLER WMRP MS appliance can be used by children aged 16 years and above and by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, provided they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved. Children shall not play with the appliance.

No, cleaning and user maintenance shall not be performed by children without supervision.

Keep other persons well away from your workplace. The work area is out of bounds for children and unauthorized persons. Never allow other persons to touch the soldering tool or cable.

You should protect yourself against electric shocks. The handles on soldering tools with an antistatic design are conductive.

Avoid touching earthed objects such as pipes, heaters, cookers, and refrigerators.

Do not use the soldering tool in a damp or wet environment.

Never work on voltage-carrying parts.

The soldering tip becomes very hot during soldering work, creating a risk of burns from touching the tips. After the soldering process, the tool and workpiece holder are still hot.

Always place the soldering tool in the safety rest while not in use. Ensure the safety holder is stable.

Do not touch the hot soldering tips and keep them away from flammable objects.

Only replace solder tips when they are cold.

Protect yourself against solder splashes from liquid solder by wearing appropriate protective clothing and eye protection.

When working with adhesives, pay special attention to the warning information provided by the adhesive manufacturer.

Only connect the vacuum and hot air at the designated points.

Covering the soldering iron or the safety holder poses a fire hazard. To prevent this:

Always keep objects well away from the soldering iron and safety holder.

Keep all combustible objects, liquids, or gases well away from the hot soldering tool.

Do not place or leave the hot soldering or desoldering tip on the worktop or on plastic surfaces.

Avoid unintentional operation. Disconnect the soldering tool from the power supply when not in use.

Keep explosive and flammable objects well away from the device.

When not in use, units and tools should be stored in a dry, high, or locked area out of the reach of children. Make sure that unused soldering tools are free of voltage and de-pressurised.

Be alert and pay attention to what you are doing. Be smart when using the unit and do not use the soldering tool if you are having difficulty concentrating.

Avoid abnormal posture. Arrange your work station in an ergonomically correct way. Avoid bad posture when using the unit, as this can lead to postural problems.

Use the WELLER WMRP MS soldering iron exclusively for soldering and desoldering under the conditions specified in the operating instructions. The soldering iron may only be used in combination with Weller Supply Units.

This device may only be used at room temperature and indoors. Protect it against moisture and direct sunlight.

Due to differing degrees of risk and potential hazards, certain work steps may only be performed by trained experts as outlined below:

Before doing any work on the machine, pull the plug out of the socket and leave the unit to cool down.

Only replace the soldering tips when they are cold.

The soldering tool must be left switched off in the safety rest for at least 3 minutes until the soldering tip has cooled down.

The WELLER WMRP MS soldering tool has an internal usage sensor which can be used to set an automatic switch-off function (Stand-by). The settings can be found in the station’s operating instructions.

The required equipotential bonding to the soldering tip can be established via the supply unit used. The connection options for an equipotential bonding cable are described in the operating instructions for the supply unit.

Waste electrical and electronic equipment must be collected and disposed of separately. Retailers may have an obligation to take back waste electrical and electronic equipment free of charge. Your contribution helps to reduce the demand for raw materials. Waste electrical and electronic equipment contains valuable, recyclable materials, which can adversely impact the environment and human health if not disposed of in an environmentally compatible manner. Delete any personal data from the waste equipment.

Contaminated filters must be treated as special waste. Dispose of replaced equipment parts, filters, or old devices in accordance with the rules and regulations applicable in your country.