Free English VOXX PRESTIGE APS-57 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD VOXX PRESTIGE APS-57 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the features of the VOXX PRESTIGE APS-57?
The features include:
2 Three Button Programmable RF Transmitters
Three Channel Receiver (capable of accepting 4 transmitters)
Keyless Entry Outputs (+) and (-)
Trunk Release Output
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
Tach Signal Learning Circuit
Two ( + ) and Two ( – ) Safety Shutdown Circuits
Alarm By-Pass Output
Accessory Outputs (Pulse Before & After Start, During Crank & After Shut Down)
Selectable Steady or Flashing Parking Lights for Run Indication
Selectable 5, 10, 15, 20 Minute Run Time
Selectable 1 Sec., 3.5 Sec., or 1 Sec./Dbl 1 Sec. Door Lock Output Pulse
Car Finder Mode
How do I use the Keyless Entry on the VOXX PRESTIGE APS-57?
The Lock button on the transmitter is used to lock the vehicle’s doors, the Unlock button is used to unlock the vehicle’s doors. To lock or unlock the doors simply press and release the desired function button one time. As a keyless entry unit, for your convenience, the parking lights will flash once when the doors are locked and twice when the door are unlocked.
How do I use the Remote Car Finder mode on the VOXX PRESTIGE APS-57?
The Lock or Unlock buttons are also used to access the car finder mode. This feature is particularly useful in a crowded parking lot where finding your car may be difficult.
To access the car finder mode, while within range of your car, simply press and hold either the lock or unlock button of your transmitter for three seconds. The parking lights will begin to flash making your vehicle more visible. The lights will stop automatically after 30 seconds.
If you wish to turn off the car finder mode prior to the expiration of the 30 second timer, press and release either the lock or unlock button of your transmitter one time.
How do I operate the Remote Trunk Release on the VOXX PRESTIGE APS-57?
If you have electric trunk release in your vehicle and the remote trunk release option was added to your vehicle, simply press and hold the Key/Trunk button of your keychain transmitter for 4 seconds or until the electric trunk of your vehicle opens.
What conditions will prevent the VOXX PRESTIGE APS-57 from remote starting the vehicle?
The unit will not start the vehicle if any one of the following situations exists:
The vehicle’s hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
How do I remote start the vehicle using the VOXX PRESTIGE APS-57?
To start the vehicle, press and release the Key/Trunk button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center.
How do I drive the vehicle after remote starting it with the VOXX PRESTIGE APS-57?
When you arrive at the vehicle, turn the ignition key to the ON position (not the spring loaded start position), then step on the brake pedal to disengage the remote starter. The vehicle will continue to run, but now on its own power.
How can I stop the remote start cycle early on the VOXX PRESTIGE APS-57?
The engine will stop running before the pre-programmed run cycle has expired if you perform any one of the following functions:
Press and release Key/Trunk button on the keychain transmitter two times within 2 seconds.
Depress the brake pedal.
Open the vehicle’s hood.
Place the unit in the safety control disabled mode.
How do I use the PRLED Safety Control Switch on the VOXX PRESTIGE APS-57 to enter Service Mode?
The Push-Button LED control switch allows you to temporarily disable the remote starting function of the system. This is recommended whenever the vehicle is being serviced. To place the system in the service mode:
1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the PRLED on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long flashes and continues this pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote start is in the service mode and will not start from RF or any other input Pulse or otherwise.
How do I exit Service Mode (R/S Override Mode) on the VOXX PRESTIGE APS-57?
To Exit R/S Override Mode:
1) With the system disarmed, Press and Hold the PRLED on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one again.
What is the Function Setting Chart for the VOXX PRESTIGE APS-57?
The following chart illustrates function settings to be completed by the installer:
| Run Time | 5 Min □ | 10 Min □ | 15 Min □ | 20 Min □ |
| Door Lock Timer | 1 Sec/1 Sec □ | 3.5 □ | 1 Sec/Dbl 1 Sec □ | |
| Lights | Pulse □ | Steady □ |
CLICK HERE TO DOWNLOAD VOXX PRESTIGE APS-57 (01) PDF DOCUMENT