VERTIV COOLPHASE WLM110A (01) PDF Document

You must observe the following safety information before handling the VERTIV COOLPHASE WLM110A:

WARNING: There is a risk of the unit falling over. Improper handling can cause equipment damage, injury, or death. Read all handling and unpacking instructions before attempting to move, lift, remove packaging from, or prepare the unit for installation.

CAUTION: There is a risk of contact with sharp edges, splinters, and exposed fasteners, which can cause injury. Always wear appropriate OSHA approved personal protective equipment (PPE).

When moving a single VERTIV COOLPHASE WLM110A unit without a pallet, two people are required to carry it.

To prevent damage from improper storage, keep the VERTIV COOLPHASE WLM110A unit indoors and protected from dampness, freezing temperatures, and contact damage.

Upon arrival of your VERTIV COOLPHASE WLM110A, you should verify that the labeled equipment matches the Bill of Lading. Carefully inspect all items for either visible or concealed damage. Any damage should be immediately reported to the carrier and a damage claim filed.

The recommended equipment for handling the VERTIV COOLPHASE WLM110A is a Fork Lift or a Pallet Jack.

When transporting the packaged VERTIV COOLPHASE WLM110A, follow these guidelines:

• Use a forklift or pallet jack.

• If using adjustable forks, spread them to the widest allowable distance that will still fit under the pallet. Ensure the fork length is suitable for the pallet length.

• The packaged unit should not be lifted any higher than 2 to 4 inches (51-102mm) off the ground when handled.

• All by-standing personnel must be no closer than 12 feet (3.7m) to the handled packaged unit.

• If circumstances require the unit to be lifted higher than 4 inches (102mm), great care must be exercised, and all by-standing personnel must be no closer than 20 feet (5m) to the lift point of the unit.

The following tools and equipment are required to unpack the VERTIV COOLPHASE WLM110A:

• Safety boots.

• Gloves to avoid splinters when the panels are being handled.

• Forklift or Pallet Jack to move the unit closer to its final location.

Follow these instructions to unpack the VERTIV COOLPHASE WLM110A:

1. Place the cardboard box on a flat surface and cut the straps to release the lid.

2. Take the cardboard lid out of the box.

3. Remove the foams that protect the unit and take the accessories out.

4. Remove the plastic bag and take the Indoor unit out of the packaging base.

Most materials used to package the VERTIV COOLPHASE WLM110A are recyclable. You should save the material for future use or appropriately dispose of it.