TRIHEAR LIBERMORE (01) PDF Document

Receiver Components:

• Power on/off & mode switch

• Sound port

• Charging contacts

• Volume down button

• Indicator light

• Microphone port

• Volume up button

Remote Microphone Components:

• Microphone sound collecting hole

• 3.5mm audio port

• Back clip

• Type-C charging port

• Power on/off & mute switch

• Indicator light

Please use the provided AC power cord and connect it to the power plug interface on the charging box. During charging, the green indicator light on the corresponding position in the box will flash. When the power reaches 100%, the green light will stay on. The charging time is approximately 1 hour. It is recommended to fully charge the device before using it for the first time.

Wear the receiver on your ears and adjust the angle to make it stable and comfortable. Clip the remote microphone on the speaker’s chest. Note: Make sure the receivers are turned off before wearing them.

Press and hold the receiver power button for 2 seconds to turn the device on or off.

Turning On: The green light will light up, a voice will announce the battery level, and the device will default to remote microphone mode.

Turning Off: The green light will flash quickly and then go out.

Note: If the receiver is not connected to an audio device or remote microphone within 10 minutes, it will automatically shut down.

Press and hold the remote microphone power button for 2 seconds to turn the device on or off.

Turning On: The white light will light up, and it will automatically connect to the receivers.

Turning Off: The green light will flash quickly and then go out.

The receiver has two modes: remote microphone mode and Bluetooth mode. To switch between these modes, click the receiver power button.

First, ensure the receiver is in Bluetooth mode. Then, turn on the Bluetooth function on your phone or other Bluetooth device. Find “Trihear Liber” in the list of available devices and click to connect. You will hear “Connected” to indicate a successful connection.

1. Click the receiver volume +/- button to adjust the volume.

2. When the maximum or minimum volume is reached, you will hear a “maximum volume” or “minimum volume” prompt tone.

3. The listening volume level from before the last shutdown will be memorized for the next time the device is turned on.

4. In remote microphone mode, the volume can be adjusted in 9 levels.

5. In Bluetooth mode, the volume can be adjusted in 16 levels.

While in remote microphone mode, click the remote microphone power button to enter mute mode. The orange light on the right will turn on. To exit mute mode, click the power button again, and the orange light will turn off.

When the receiver is in Bluetooth mode, click the power button 5 times in succession to clear the Bluetooth pairing record. After successfully clearing the history, the receiver will automatically shut down.

Receiver: When the receiver is in a low power state, you will hear a voice reminder saying “battery low”.

Remote Microphone: When the remote microphone is in a low power state, the white indicator light on the left will flash quickly.

1. In remote microphone mode, quickly click the receiver power button 3 times. The green light on the receiver will flash quickly.

2. Quickly click the remote microphone power button 3 times. The green light on the microphone will flash quickly.

3. Put the receiver and remote microphone close together, and quickly click the remote microphone power button 3 times again. The green lights on both devices will turn to slow flashing, which indicates a successful pairing.