TOWER T19051RD (01) PDF Document

The box contains:

Instruction Manual

Mini Chocolate Fountain

The parts of the fountain are:

1. Spiral Auger (not shown)

2. Tower

3. Chocolate Bowl

4. Control Switch

Please read these notes carefully BEFORE using your TOWER T19051RD appliance:

• Check that the voltage of the main circuit corresponds with the rating of the appliance before operating.

• Please ensure that the appliance is used on a stable, level, and heat resistant surface.

• DO NOT immerse cords, plugs or any part of the appliance in water or any other liquid.

• DO NOT leave the appliance unattended while it is operating.

• Close supervision is necessary when any appliance is used by or near children or pets.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

• Children shall not play with the appliance.

• Cleaning and user maintenance shall not be made by children without supervision.

• Switch off at the wall socket then remove the plug from the socket when not in use or before cleaning.

• If the supply cord or appliance is damaged, stop using the appliance immediately and seek advice from the manufacturer or its service agent or a similarly qualified person.

• DO NOT let the cord hang over the edge of a table or counter or let it come into contact with any hot surfaces.

• The use of accessory attachments is not recommended by the appliance manufacturer, apart from those supplied with this product.

• DO NOT pull the plug out by the cord as this may damage the plug and/or the cable.

• DO NOT use this product for anything other than its intended use.

• This appliance is for household use only.

• DO NOT carry the appliance by the power cord.

• DO NOT use the appliance outdoors.

• Ensure the product is not too close to any heating appliances or other sources of heat.

• This product is NOT a toy.

• Never leave the appliance within reach of children.

• DO NOT use the appliance underneath a wall mounted cupboard.

• This product should not be used with timers or remote devices as to do so would be a potential fire hazard.

• Never assemble, disassemble or clean when the product is connected to the mains supply.

• In the unlikely event the appliance develops a fault, stop using it immediately and seek advice from the Customer Support Team.

There are also symbols on the appliance indicating HIGH VOLTAGE and HOT SURFACE.

1. Place the chocolate fountain on a firm, level surface. It is very important that the surface is level or the chocolate will not flow properly.

2. Place the spiral auger onto the motor base pin. The triangular slot will fit tightly over the motor base pin.

3. Place the tower over the spiral auger and fit into the guiding pins.

1. Connect the chocolate fountain to the mains supply and turn the control switch to the Heat setting to start the pre-heating process. Allow the appliance to pre-heat for about five minutes before adding in the melted chocolate.

1. Melt the chocolate (approx 200g) in a pan or in a microwave. Add 1/2 – 3/4 cup of vegetable oil to thin the mixture. If available you can add melted cocoa butter instead of oil.

2. Carefully pour the chocolate mixture into the bowl on the base of the chocolate fountain. Fill the bowl so that it just covers the guiding pins.

3. Turn the control switch to the Heat Motor setting to activate the unit’s motor and begin the dispensing process. Please note: it may take 2-3 minutes for any air bubbles to settle and the chocolate to flow perfectly.

• Un-thinned chocolate is unlikely to flow properly, if at all. The more oil you add the more smoothly, the chocolate will flow. A good test is to use a large spoon to check the flow of the mixture before adding to the chocolate fountain. Dip the spoon into the chocolate mix then pour the chocolate off the spoon. It should flow smoothly in a constant stream.

• The type of chocolate you use will determine how smoothly the chocolate flows over the tiers. Good quality chocolate will give better results as it has a higher percentage of cocoa butter.

• Many foods are suitable for dipping in the chocolate.

• You can add a small amount of warmed liqueur to the mix.

• If the fountain is dripping instead of flowing, this indicates that the mixture may be too thick. Just add some warmed vegetable oil.

• If the chocolate is not flowing in smooth sheets, it could mean the unit is not on a level surface.

• Try not to allow pieces of food to fall into the mixture as this could interfere with the smooth flow of the chocolate.

1. Before cleaning, turn off the appliance and remove the mains plug from the mains supply.

2. Make sure the Chocolate Fountain has cooled down completely before cleaning.

3. Remove the tower and spiral auger. Wash in hot, soapy water. Rinse and dry thoroughly.

4. Use a damp cloth to clean the remaining chocolate from the base. Dry thoroughly.

When the Chocolate Fountain is not in use, disconnect it from the mains supply and store it in a safe, dry place, out of reach of children.

The wires in the mains lead are labelled in accordance with the following code: Blue neutral [N] Brown live [L] Green/Yellow [EARTH].

For plug fitting:

• The wire labelled blue is the neutral and must be connected to the terminal marked [N].

• The wire labelled brown is the live wire and must be connected to the terminal marked [L].

• The wire labelled green/yellow must be connected to the terminal marked with the letter [E].

• On no account must either the brown or the blue wire be connected to the [EARTH] terminal.

• Always ensure that the cord grip is fastened correctly.

• The plug must be fitted with a fuse of the same rating already fitted and conforming to BS 1362 and be ASTA approved. If in doubt consult a qualified electrician.

WARNING: This appliance MUST be earthed!

If your appliance is supplied with a non-rewireable plug fitted to the mains lead and should the fuse need replacing, you must use an ASTA approved one (conforming to BS 1362 of the same rating). If in doubt, consult a qualified electrician.

If you need to remove the plug – disconnect it from the mains – then cut it off of the mains lead and immediately dispose of it in a safe manner. Never attempt to reuse the plug or insert it into a socket outlet as there is a danger of an electric shock.

Appliances bearing the symbol of a crossed-out wheeled bin may not be disposed of in domestic rubbish. You are required to dispose of old electrical and electronic appliances like this separately.

The WEEE directive, introduced in August 2006, states that all electrical items must be recycled, rather than taken to landfill.

Please arrange to take this appliance to your local Civic Amenity site for recycling, once it has reached the end of its life.