TOSHIBA B-FP2D-GH50-CN-S (01) PDF MANUAL

1. Open the battery cover by sliding the release latch.

2. Insert the battery pack into the compartment.

3. Close the battery cover, ensuring it clicks into place.

Align the belt clip with the corresponding slots on the back of the printer and slide it down until it locks firmly in place.

1. Connect the AC adapter cable to the power port on the side of the printer.

2. Plug the power cord into the AC adapter.

3. Plug the other end of the power cord into a wall outlet.

1. Open the printer’s top cover.

2. Pull the two media holder tabs outwards to open them.

3. Insert the media roll between the holders.

4. Push the media holders inwards to secure the roll.

5. Feed the end of the media through the front slot.

6. Close the top cover until it snaps shut.

7. Tear off the excess media using the tear bar.

1. Obtain and run the printer driver installation file on your computer.

2. Follow the on-screen instructions in the InstallShield Wizard. Agree to the license terms and click Next.

3. Click “Install” to begin the driver installation process.

4. When prompted or when the installation is complete, connect the printer to your computer with a USB cable.

5. Turn the printer on by pressing the power button.

6. Your computer will recognize the device, and it will be available in the “Printers & scanners” section of your system settings.

The printer’s display screen shows the following status indicators:

POWER: Indicates the power status.

FEED: Relates to the media feeding function.

STATUS: Shows the general operational status of the printer.

CHARGE: Indicates the battery’s charging status.