Free English TOA YM-3CM (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD TOA YM-3CM (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the specifications for the TOA YM-3CM and related models?
| Model No. | Connector | Applicable connector | Allowable current (AC) | Accessories |
|---|---|---|---|---|
| YM-1J | Double pole jack | Single or double pole plug | — | Screw ……….. 2 |
| YM-3CF | XLM-3-31PCH-R | XLR-3-12C | 3 A | |
| YM-3CM | XLM-3-32PCH-R | XLR-3-11C | 3 A | |
| YS-4CF | XLR-4-31-F77 | XLR-4-12C | 10 A | |
| YS-4CM | XLR-4-32-F77 | XLR-4-11C | 10 A |
Applicable plate (common to all models): YP-1AF Plate (optional)
XLM type and XLR type connectors are the products of ITT Corporation.
What are the recommended dimensions for the mounting opening for the TOA YM-3CM?
To fit the electrical box in the wall or ceiling, make an opening according to the following dimensions:
Width: 46 – 50 mm (1.81 – 1.97 in)
Height: 90 – 98 mm (3.54 – 3.86 in)
What should I do if a low-voltage circuit and a low-power circuit are housed in the same box for my TOA YM-3CM?
When a low-voltage circuit and a low-power circuit are housed in the same box, you must provide a partition to isolate them from each other.
What types of cables are applicable for use with the TOA YM-3CM and other models?
| YM-1J, YM-3CF, YM-3CM | Microphone vinyl cable, Cross-sectional area: 0.75 – 2.0 mm² (AWG 18 – 14) |
| YS-4CF, YS-4CM | 600 V vinyl-insulated cable or equivalent, Diameter: 0.8 – 1.6 mm (AWG 20 – 14) or Cross-sectional area: 0.9 – 2.0 mm² (AWG 17 – 14) |
Are there any special instructions for cable installation with the TOA YM-3CM?
Yes, please note the following:
• For cables with a sectional area of under 0.75 mm², fold back their cores to increase the sectional area before connection.
• If a thick cable is used, the circuit board can be damaged when mounting the connector in an electrical box. Take care that excessive force is not applied to the circuit board when mounting.
How do I wire the TOA YM-3CM connector?
The pin connections for the TOA YM-3CM are as follows:
• Pin 1: E (Shield)
• Pin 2: H [USA type: – (C)]
• Pin 3: C [USA type: + (H)]
Key:
H: Hot
C: Cold
E: Shield
Are there any limitations when using the TOA YM-3CM or related connectors?
Yes. As H (Hot), C (Cold), and E (Shield) are shorted when not used, mixers or amplifiers using phantom power cannot be used.
CLICK HERE TO DOWNLOAD TOA YM-3CM (01) PDF DOCUMENT