TOA AT-4030B-EB (01) PDF MANUAL

TOA AT-4030B-EB (01) PDF SUMMARY:

How do I obtain optimum results from this unit?

Please follow the instructions manual to obtain the optimum results from this unit. We also recommend that you keep this manual handy for future reference.

What is the strip length for the shield of the cable?

Strip the shield of the cable approx. 9mm.

After stripping the shield of the cable, what is the next step?

After loosening the screws at terminal block, insert the core of the cables fully into the specified terminal block. Tighten the screws and make sure the cables are not loose.

How do I prepare for installation?

To prepare for installation, mark the 4 holes on the wall with the back box as shown in the picture.

What is the usable cable range?

22 – 14 AWG

What is the recommended cable range for solid copper wire?

0.6mm – 1.6mm

What is the recommended cable range for stranded copper wire?

0.8mm – 2mm

What does N.C stand for?

N.C is NOT CONNECTED

What is the first step in Flush Mounting with Back Box?

To prepare for installation, mark the opening on the wall with rectangular pattern as shown in the picture.

What is the second step in Flush Mounting with Back Box?

Connect the recommended cable to the terminal.

What is the warning associated with connecting 4-wire attenuator system?

WARNING : Do not supply 24V DC when connecting 4-wire attenuator system.

What is the third step in Flush Mounting with Back Box?

Install the main unit to the back box.

What is the fourth step in Flush Mounting with Back Box?

Attach the cover panel to the main unit attenuator until the hook mount clips perfectly.

What is the first step in Flush Mounting without Back Box?

To prepare for installation, mark the opening on the wall as shown in the picture. This mounting method can be used for all models.

What is the second step in Flush Mounting without Back Box?

Make opening on the wall.

What is the third step in Flush Mounting without Back Box?

Connect the recommended cable to the terminal.

What is the warning associated with connecting 4-wire attenuator system?

WARNING : Do not supply 24V DC when connecting 4-wire attenuator system.

What is the fourth step in Flush Mounting without Back Box?

Install the main unit directly to the wall using screws that are suitable for the kind of wall.

What is the fifth step in Flush Mounting without Back Box?

Attach the cover panel to the main unit attenuator until the hook mount clips perfectly.

Where can I find the traceability information for Europe?

Traceability Information for Europe Manufacturer: TOA Corporation 7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo, Japan Authorized representative: TOA Electronics Europe GmbH Suederstrasse 282, 20537 Hamburg, Germany