FREE ENGLISH TEAC R-505 (01) PDF USER GUIDE
FREE ENGLISH TEAC R-505 (01) PDF USER MANUAL
FREE ENGLISH TEAC R-505 (01) PDF OWNER GUIDE
FREE ENGLISH TEAC R-505 (01) PDF OWNER MANUAL
FREE ENGLISH TEAC R-505 (01) PDF REFERENCE GUIDE
FREE ENGLISH TEAC R-505 (01) PDF INSTRUCTION GUIDE
FREE ENGLISH TEAC R-505 (01) PDF REFERENCE MANUAL
FREE ENGLISH TEAC R-505 (01) PDF INSTRUCTION MANUAL
FREE ENGLISH TEAC R-505 (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD TEAC R-505 (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is the recommended operation position for the Stereo Cassette Deck?
The recommended operation position is Horizontal.
When is lubrication required for the cassette deck?
Lubrication is only required when parts are replaced. For this purpose, use the oil specified below:
Oil: TEAC spindle oil (from TEAC TZ-255 oil kit), Mobil D.T.E. oil Light, or equivalent.
Apply a drop of oil with an oil applicator to a point about 1/3 the way down the shaft (from the free end) of the flywheel, then insert the shaft into the capstan housing.
How do I perform voltage conversion for General Export Models?
1. ALWAYS DISCONNECT THE POWER LINE CORD BEFORE MAKING THESE ADJUSTMENTS!
2. Locate the voltage selector on the rear panel.
3. Using a regular screwdriver, turn the selector until the numerals corresponding to the voltage requirements of your area appear.
What precautions should be taken before performing adjustments and checks?
1. Before performing adjustments and checks clean and demagnetize the entire tape path.
2. Make sure the deck is properly set for the voltage in your locality.
What are the default deck settings for Playback Performance checks?
The deck settings are:
MPX FILTER Sw: OUT
NR SYSTEM sw: OUT
What are the default deck settings for Monitor Performance checks?
The deck settings for RECORD-PAUSE mode are:
NR SYSTEM sw: OUT
MPX FILTER sw: OUT
What are the default deck settings for Recording Performance checks?
The deck settings are:
NR SYSTEM sw: OUT
MPX FILTER sw: OUT
RECORD cont. (L/R): Spec. position (item 8)
BIAS FINE cont. (L/R) (R-606X/V-550X): “O” position
What is the caution regarding parts marked with a specific sign?
Parts marked with this sign (triangle symbol) are safety critical components. They must always be replaced with identical components. Refer to the appropriate parts list and ensure exact replacement.
CLICK HERE TO DOWNLOAD TEAC R-505 (01) PDF MANUAL