SWAN TEASMADE STM200N (01) PDF MANUAL

Always ensure that the voltage on the rating label corresponds to the mains voltage in your home.

Incorrect operation and improper use can damage the appliance and cause injury to the user.

Check the power cord and plug regularly for any damage. If damaged, it must be replaced by the manufacturer or qualified person to avoid hazards.

Do not use the appliance if it has been dropped or damaged. Take it to an authorised service agent for examination/repair.

Never immerse the unit in water or any other liquid.

Remove the plug from the socket by gripping the plug, not pulling the cord.

Always unplug the unit when not in use, before cleaning, or when adding/removing parts.

Use only manufacturer-recommended or supplied accessories.

Keep the cord away from table edges, hot surfaces, hot gas/electric burners, or heated ovens.

Do not use the appliance on a gas or electric cooking top or near an open flame.

An extension cord is not recommended. If used, ensure it suits the appliance’s power consumption and is placed safely.

This appliance is not suitable for outdoor use.

Use the appliance only for its intended purpose.

Do not carry the appliance by the power cord.

Do not leave the appliance unattended during use.

Always operate on a smooth, even, stable surface. Do not place on a hot surface.

Ensure the unit is switched off after use.

In case of technical problems, switch off and do not attempt self-repair. Return to an authorised service facility. Use original spare parts.

Do not switch on via an external timer or separate remote control system.

This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.

Remove all packaging. Perform an initial cleaning cycle:

1. Fill the ceramic jug with water to 1” (25mm) below the top.

2. Open the lid and remove the tank cap by turning it anti-clockwise.

3. Pour the water from the jug into the tank and replace the tank cap by turning it clockwise.

4. Place the ceramic jug back on its stand, ensuring it is resting firmly against the safety switch.

5. Press the TEA NOW button and wait.

6. In a few minutes, the water will boil and be ejected into the pot with a ‘woosh’ sound.

7. Once this process is complete, discard the water from the pot.

Your TEASMADE is now clean and ready to use.

Important: Do not remove the teapot during the filling cycle. Ensure the tank cap is properly secured after filling and do not open it during the boiling cycle. Wait a few minutes after the cycle before removing the filler cap as it will be hot. DO NOT OVERFILL.

Insert the plug into the mains socket. The clock hands will default to the 12:00 position.

Press the CLOCK SET button repeatedly to advance the clock hands to the correct time. Each press advances the clock by 1 minute.

To fast forward the clock, press and HOLD the CLOCK SET button.

Note: The TEASMADE uses a 12-hour clock with no am or pm setting.

The dot on the clock face indicates the alarm time.

Press the ALARM SET button repeatedly to advance the alarm time (indicated by the dot) to the desired time. Each press advances the time by 1 minute.

To fast forward the alarm time, press and HOLD the ALARM SET button.

Once you release the ALARM SET button, the clock will revert to showing the current time, and the alarm dot will remain displayed at the set alarm time.

Note: The TEASMADE uses a 12-hour clock with no am or pm setting.

After setting the time, press the ALARM button so that it lights up. The alarm is now set.

When the alarm time is reached, the unit will beep. Press the ALARM button to stop the beeps.

Ensure the ALARM button is lit if you want the alarm to activate.

1. Fill the tank with water as described in the initial setup (use the ceramic jug, pour water into the tank, secure the cap).

2. Put 2 tea bags (or 2 teaspoons of instant coffee) into the ceramic pot.

3. Place the pot back onto the TEASMADE stand, ensuring it is resting firmly against the safety switch.

4. Press the TEA NOW button.

5. The tea making process will begin and takes approximately 5 minutes.

6. The cycle finishes with the traditional TEASMADE ‘woosh’ as the hot water is ejected into the pot.

To interrupt the tea making cycle, press the TEA NOW button again. The cycle will stop.

If you require more tea, wait a few minutes between cycles to allow the tank to cool.

To use the reading light, simply press the reading light button (indicated by a lightbulb symbol).

Ensure the product is unplugged and completely cooled before cleaning.

Clean the ceramic pot daily with warm soapy water, then rinse with clean water.

Do not leave water in the tank for long periods. Wait until the product has cooled before emptying the tank.

Clean the outside of the unit with a soft cloth moistened with a mild detergent solution.

DO NOT USE CHEMICAL OR ABRASIVE CLEANERS.

DO NOT IMMERSE THE UNIT IN WATER.

Excessive limescale build-up can harm the Teasmade. It’s important to descale regularly for best performance. Refer to the limescale guide on the inner lid of the retail box.

1. Use a good descaling agent (available from most supermarkets).

2. Fill the tank using the pot and include the descaling agent according to its instructions.

3. On this occasion, LEAVE THE FILLER CAP OFF the tank.

4. Place the empty pot on its stand, ensuring it is in contact with the safety switch.

5. Press the TEA NOW button. The water in the tank will boil.

6. Note: With the filler cap off, there will be an increased amount of steam, so be careful.

7. Once the water in the tank is boiling, press the TEA NOW button again to switch it off.

8. Carefully replace the filler cap onto the tank.

9. Press the TEA NOW button once again. The boiling water with the descaler will be ejected into the pot, descaling the internal pipes and tubes.

10. Once descaling is complete, allow the unit to cool.

11. Rinse the tank and pot thoroughly with clean water.

Jug: STM200-01

Reading light bulb: STM200-02

If you need to order parts, call the helpline number on the cover of the instruction manual or visit http://www.swan-brand.co.uk.

This product is guaranteed for 2 years from the date of original purchase.

If any defect arises due to faulty materials or workmanship, the faulty product must be returned to the place of purchase. Refunds or replacement are at the discretion of the store.

The following conditions apply:

• The product must be returned to the retailer with proof of purchase.

• The product must be installed and used in accordance with the instructions contained in the instruction guide.

• It must be used only for domestic purposes.

• It does not cover wear and tear, damage, misuse, or consumable parts.

• Swan Products Ltd has limited liability for incidental or consequential loss or damage.

• This guarantee is valid in the UK and Eire Only.

The wires in the mains lead are coloured as follows:

• BLUE: NEUTRAL – Connect to the terminal marked N or coloured black.

• BROWN: LIVE – Connect to the terminal marked L or coloured red.

• GREEN/YELLOW: EARTH – Connect to the terminal marked E or with the earth symbol, coloured GREEN or GREEN/YELLOW.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Appliances bearing the crossed-out bin symbol must not be disposed of in domestic rubbish. You must dispose of old electrical and electronic appliances separately. Visit http://www.recycle-more.co.uk or http://www.recyclenow.co.uk (UK) or http://www.weeeireland.ie (Ireland) for information on recycling electrical items. Arrange to take this appliance to your local Civic Amenity site for recycling when it reaches the end of its life.

Description: Teasmade

Model: STM200N

Input Voltage: 230-240V

Frequency: 50Hz

Power consumption: 780-850 Watts