Free English SUPTEK BYPA02 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SUPTEK BYPA02 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What are the safety warnings for the SUPTEK BYPA02 bike mount?
Please adhere to the following warnings when installing and using the SUPTEK BYPA02:
1. Please do not exceed the maximum load. Overweight may cause damage or drop of equipment.
2. Fits wooden wall, brick wall or concrete wall. Do not mount on drywall.
3. Walls must be able to carry 5 times the weight (total weight of the bike plus wall mount).
4. Please read the installation instructions carefully.
What parts and tools are included with the SUPTEK BYPA02?
The following parts are included with your SUPTEK BYPA02:
A (1) – Main hook assembly
B (1) – Lower wheel bracket part
C (1) – Lower wheel bracket part
D (2) – Self-tapping screw ST6X50
E (2) – Self-tapping screw ST4.8X50
F (4) – Plastic anchor
Tools such as a drill, drill bits, and a pencil are not included.
How do I assemble the lower wheel bracket for the SUPTEK BYPA02?
To assemble the lower wheel bracket, connect part B and part C as shown in the user manual diagrams.
How do I install the SUPTEK BYPA02 on a wooden wall?
Follow these steps for wooden wall installation:
1. Before installation, measure the distance between your bike’s two tires to determine the correct placement for the upper and lower mounts.
2. Draw your mounting points and punch holes directly into the wooden studs.
3. Use a Ø3mm drill bit to drill holes to a depth of at least 55mm (≥55mm).
4. Install the main hook assembly (A) using two self-tapping screws ST6X50 (D).
5. Install the assembled lower wheel bracket (B+C) using one self-tapping screw ST4.8X50 (E).
How do I install the SUPTEK BYPA02 on a solid wall like brick or concrete?
Follow these steps for solid wall installation:
1. Before installation, measure the distance between your bike’s two tires to determine the correct placement for the upper and lower mounts.
2. Draw your mounting points and punch.
3. Use a Ø10mm drill bit to drill holes to a depth of at least 55mm (≥55mm).
4. Insert two plastic anchors (F) into the upper holes and two plastic anchors (F) into the lower holes.
5. Install the main hook assembly (A) using two self-tapping screws ST6X50 (D).
6. Install the assembled lower wheel bracket (B+C) using two self-tapping screws ST4.8X50 (E).
How do I adjust the hook position on the SUPTEK BYPA02?
The hook on the main hook assembly (A) can be moved up or down along its track to adjust its position. Slide it to the desired height to best fit your bike.
How do I hang my bike on the SUPTEK BYPA02?
Once the SUPTEK BYPA02 is installed and the hook is adjusted to the correct height, hang your bike by placing its front wheel onto the hook. The rear wheel should rest on the lower wheel bracket.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD SUPTEK BYPA02 (01) PDF DOCUMENT