SUNCAST WTS175 (01) PDF Document

Before using the SUNCAST WTS175, please observe the following cautions and instructions:

Read instructions thoroughly prior to assembly. This product contains parts that can be damaged if incorrectly assembled.

Check for all parts before you begin assembly using the provided parts check list.

The product is not intended for use by children.

This product may become susceptible to impact damage in freezing temperatures.

DO NOT store near excessive heat.

DO NOT sit or stand on the hose reel.

When attaching the garden hose to the hose reel out-tube, be careful not to cross-thread, as this could cause permanent damage.

To install the SUNCAST WTS175, you will need the following tools:

Drill with a 5/32″ drill bit

Tape measure

Pencil

Screwdriver or driver with a 5/16″ socket

Follow these steps to mount the SUNCAST WTS175:

1. Mark the location for mounting the hose reel on the wall by measuring 36″ from the left side of the unit to the water supply and measuring 51 3/4″ from the ground. Note: If the hose reel is correctly mounted, the leader hose should reach the water supply without kinking the hose.

2. Line up the hose reel with your measurements and mark the hole locations. Note: Hardware supplied is for mounting the unit to wood. Consult your local hardware store for alternate mounting supplies and instructions. It is recommended to use a 5/16″ socket and small extension to install fasteners.

3. Pre-drill holes. Install the top two hex head screws halfway. DO NOT tighten them yet.

4. Mount the hose reel on the top two hex head screws.

5. Install the bottom two hex head screws and tighten all four screws. Note: DO NOT overtighten screws.

Connecting the Leader Hose:

Connect the male end of the leader hose to the in-tube and the female end to the spigot.

Connecting the Garden Hose:

Connect the garden hose to the out-tube. Turn on the water supply and check for leaks. If necessary, tighten connections.

Caution: DO NOT cross-thread the garden hose onto the out-tube. Check that the garden hose has a washer inside the female coupler. If the washer is missing, consult your local hardware store for the correct washer needed.

During installation, push the tabs and raise the tracker arms. Run the garden hose end through the tracker.

To operate, run the hose through the tracker and slide the tracker as needed. Push the tabs to lower the tracker arms once the hose is through.

When finished using the hose reel, turn off the water source. DO NOT leave water pressure on when not in use.

Before rewinding your hose, remove the accessory and drain as much water out of the hose as possible. This will prevent extra stress on the hose reel (from the weight of water) that could cause permanent damage.

To unwind your hose, pull the hose out away from your hose reel in a straight line. Then walk the end back to the hose reel so the hose is in a “U” shape in front of the reel. This assists in easier rewinding of the hose.

If freezing may occur, remove the hose from the faucet and drain water out of the hose and reel. Freezing of trapped water may cause damage to the reel, hose, or pipes.

Store the unit indoors during colder months. Check in-tube and out-tube connections prior to first use each spring.

Once a year, remove the in-tube and clean and re-lube the o-rings. Re-install the in-tube.

Depending on usage and water hardness, the in-tube and out-tube connection may become worn and start to leak.