Free English SONY PFM-50C1 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SONY PFM-50C1 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
Which cables should be used when connecting the SONY PFM-50C1 to equipment using RGB/YUV connectors?
When connecting this unit to various pieces of equipment using the RGB/YUV connectors, use the specified cable:
SMF-400 (DSub- DSub 15P)
MTSB-15HKBB-18 (DSub 15P-BNC)
When is it necessary to attach ferrite cores to the SONY PFM-50C1?
If an audio cable is connected to either INPUT1 or INPUT2, be sure to attach the supplied ferrite cores to the ends of the cable.
How do I attach the ferrite cores to the cable on the SONY PFM-50C1?
1. Attach the ferrite cores to both ends of the connector and close the ferrite cores until they click.
2. Wind the stopper round the cord so that the ferrite cores do not slide.
3. Tighten the stopper and cut the surplus.
What should I do if I notice lateral stripes on the screen when using the SONY PFM-50C1 with the BKM-B10?
If you are using the SONY PFM-50C1 with the BKM-B10 (not supplied), and you notice lateral stripes on the screen, remove the part indicated in the illustration.
CLICK HERE TO DOWNLOAD SONY PFM-50C1 (01) PDF DOCUMENT