SONY BRAVIA K-55XR80C (01) PDF MANUAL

For Sony Customer Support:

General TV Support: https://www.sony.com/tvsupport

U.S.A.: https://www.sony.com/tvsupport or call 1.800.222.SONY (7669)

Canada: https://www.sony.ca/support or call 1.877.899.SONY (7669)

Please Do Not Return the Product to the Store. Contact Sony Customer Support for assistance.

The diagrams indicate that two people should lift the TV out of the box and handle it during stand attachment. Place the TV face down on a soft, stable surface when attaching the stand to avoid damaging the screen.

1. Attach the Stand Neck (CN) to the Stand Base (SB) using two M5L16 screws. Ensure they are correctly aligned as shown in the O/X diagram.

2. Place the TV screen-down on a cushioned surface.

3. Attach the assembled stand base/neck (CC) to the back of the TV.

Yes, the setup guide shows two different mounting positions for the Stand Base (SB) feet on the Stand Neck (CC). Each position requires securing the feet with two M5L16 screws per foot. Ensure correct installation as indicated by the O/X diagrams.

The recommended torque for the M5L16 stand screws is 1.5 N·m / 1,5 N·m {15 kgf·cm}.

Connect the AC power cord securely to the AC IN port on the back of the television.

The TV includes the following ports:

AC IN (Power)

DIGITAL AUDIO OUT (OPTICAL)

S-CENTER SPEAKER IN

USB (x2, 500 mA MAX each)

HDMI IN (x4)

LAN

REMOTE Section: RS-232C, IR IN

ANTENNA/CABLE IN

HDMI IN 3 supports eARC/ARC (Enhanced Audio Return Channel / Audio Return Channel).

HDMI IN 4 supports 4K resolution at 120 Hz input.

Yes, for certain ports, cable connector dimensions should be considered:

HDMI (specifically shown near eARC/ARC port): The connector head should ideally be less than 21 mm wide and less than 12 mm high.

ANTENNA/CABLE IN: The cable connector should ideally be less than 7 mm in outer diameter, with the center pin less than 1.5 mm in diameter.

Connect the cable from your compatible audio system’s S-CENTER OUT port to the S-CENTER SPEAKER IN port on the TV.

Both ports use a 3.5 mm jack:

RS-232C (*5): Pin 1: TxD, Pin 2: RxD, Pin 3: GND/Tierra

IR IN (*6): Pin 1: IR, Pin 2: GND/Tierra

1. Gather the connected cables.

2. Use the provided cable tie/holder to bundle them together.

3. Route the bundled cables through the clip integrated into the stand leg.

4. Attach the rear covers (labeled CD, CC, CN in the diagrams) to conceal the ports and cables for a cleaner look.

Slide open the battery cover on the back of the remote control. Insert the batteries according to the polarity (+/-) markings indicated inside the battery compartment. Slide the cover back into place.

After connecting the AC power cord, press the power button (symbolized by a circle with a vertical line) located on the remote control or on the TV itself. The Sony logo should appear on the screen.

Refer to the Reference Guide (*2) included with your TV or scan the QR code shown in the troubleshooting section of the setup guide using your smartphone for additional help.

Some features or steps indicated by (*1) might only apply to limited regions, countries, or specific model variations.