Free English SERENELIFE SLSFE12 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SERENELIFE SLSFE12 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I open the SERENELIFE SLSFE12 for the first time?
Upon first use, users should open the safe with the emergency key.
To do this: Remove emergency lock cover, insert the emergency key, and turn it counterclockwise.
Turn the knob counterclockwise to open the door.
CAUTION: Finish operation, pull the emergency key out and keep it in a safe place.
How do I insert the batteries into the SERENELIFE SLSFE12?
Open the door with the emergency key.
Insert 4 X 1.5V batteries into the battery compartment. Upon inserting, the buzzer will beep and the green light will flash.
How do I know if the batteries are low on the SERENELIFE SLSFE12?
If both green and red light are on, it indicates the batteries are low and should be replaced.
How can I set the user code on the SERENELIFE SLSFE12?
With the door open, press the reset button (the red button on the battery compartment), input the 3- to 8-digit user code and press the “enter” button or the “lock” button.
2 buzzer beeps with green light flashes indicates the new user code is stored.
How do I open the door of the SERENELIFE SLSFE12 with the user code?
Input your user code. After each press, the buzzer will beep and the green light will flash, press the “enter” button or the “lock” button.
After the correct code is entered, there will be 2 buzzer beeps and the green light will flash, rotate the knob counterclockwise within 5 seconds to open the door.
CAUTION: A wrong code input will activate 3 buzzer beeps.
How do I close the door on the SERENELIFE SLSFE12?
Turn the knob clockwise to close the door.
What is the mounting method for the SERENELIFE SLSFE12?
Fix the safe in a place which is not easy to move.
Drill holes for expansion bolts (or clamping screws) in the right place.
Turn the expansion bolts counterclockwise to separate.
Use the expansion bolts (or clamping screws) to secure the case to the wall.
Make sure the case is mounted in place as required and then tighten screws.
When mounting the SERENELIFE SLSFE12, should I use expansion bolts or clamping screws?
Use the expansion bolt when there is a concrete wall surface. Use the clamping screw when there is a wooden wall surface.
How does the automatic lock function work on the SERENELIFE SLSFE12?
3 continuous wrong inputs will activate the warning beep for 20 seconds.
Another 3 continuous wrong inputs will activate the warning beep for 3 minutes.
CAUTION: The keypad will be disabled during the beeping. You can only stop the beeps by opening the safe with emergency key or removing the batteries.
CLICK HERE TO DOWNLOAD SERENELIFE SLSFE12 (01) PDF DOCUMENT