SENSORBLUE WS07 (01) PDF Document

To ensure the SENSORBLUE WS07 remains accurate, keep these two points in mind:

1. The sensor is an accurate humidity and temperature MEMS sensor, so do not put it in water.

2. The sensor detects air temperature and humidity through the hole in the back; do not cover this hole.

Follow these steps to set up your SENSORBLUE WS07:

1. Scan the QR code provided on the box or on the manual to download the app.

2. Turn on the app and ensure that Bluetooth is turned on.

3. Take off the battery sleeve to allow the sensor to start working.

4. Tap “Add device” or “+” to add the hygrometer.

5. The app will pair with the device. Press the button on the SENSORBLUE WS07, and it will connect automatically. For models without a button, tap “Pairing by device name” and choose “Thermobecon”.

To view the graphic or history data for your SENSORBLUE WS07, simply tap the temperature number or humidity number directly within the app.

You can use the app to set up your desired alert temperature or humidity for the SENSORBLUE WS07. When the device is connected to the app, you can read the instant data. If your specific model includes a buzzer alert, it will trigger if the temperature or humidity falls outside of the set range.

Follow these steps to safely replace the battery:

1. Clean your hands to ensure there is no water or oil.

2. Hold the SENSORBLUE WS07 and pull the case towards the earth to open it.

3. Push the old battery out and replace it with a new CR2477 battery.

4. Turn on the app, then press the key on the PCB board until you see the LED flash.

5. Once the temperature and humidity data appear again in the app, clip the plastic case back together.