SECO-LARM ENFORCER SL-1312-SA-C (01) PDF Document

The features of the SECO-LARM ENFORCER SL-1312-SA-C Mini Strobe Siren are:

• Synchronized piezo siren and long-life LEDs (x4)

• Surface-mount or mount to single-gang box

• High-impact plastic casing and weather-resistant design allows for indoor and outdoor use

• Available with amber, blue, clear, or red lens

• Simple 2-wire connection: red to positive, black to negative

• Alarm siren sound is 100dB@3ft (1m) at 12VDC

The ordering guide for the SECO-LARM ENFORCER SL-1312-SA-C series is as follows:

1. Consider the type of mounting and where to run the wires. The two connection wires exit the device from the lower part of the device back but also with a notch at the bottom to allow for hidden or exposed wiring.

2. Run two wires from an N.C. output of the triggering device to the Mini Strobe Siren installation location.

3. For surface mounting, mark and drill the mounting holes and holes for the wiring if needed.

NOTE: The Mini Strobe Siren mounting holes are spaced so that it can also be mounted to a standard single-gang back box.

4. Connect the red wire to the positive trigger and the black wire to the negative trigger wire.

5. Use the included mounting screws (and plastic wall anchors if needed) to mount the device taking care not to crimp the wires.

California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm.