SCARLETT COMFORT SC-DF111S19 (01) PDF Document

Read carefully Instruction manual and keep it for further reference.

Incorrect operation and improper handling can lead to malfunction of the appliance and injuries to the user.

Before switching on the appliance for the first time please check if the technical specifications indicated on the unit correspond to the mains parameters.

For home use only. Do not use for industrial purposes.

Do not use outdoors or in damp area.

The appliance is not intended for use for physically, sensory or mental disabled person (including children) or for person with lack of life experience or knowledge, if only they are under supervision or have been instructed about the use of the unit by responsible person.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.

Children must be under control in order not to be allowed to play with the appliance.

Always unplug the appliance from the power supply when not in use.

To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If it has happened DO NOT TOUCH the appliance, unplug it immediately and check in a service center.

Do not use the device in bathrooms and near water.

Do not place the appliance near heat sources.

Do not leave the switched on appliance unsupervised.

Do not use other attachments than those supplied with the appliance.

In case of power cord is damaged, its replacement should be done by the manufacture or service department or the other high-skill person to avoid any danger.

Ensure that the cord does not hang over sharp edges and keep it away from hot surfaces.

To disconnect the appliance from the power supply pull it out by the plug only, not by the cord.

Avoid contact with moving parts of the device. Do not put pencils or other objects through the protective grid of the fan.

Do not switch on the fan without well-adjusted front and rear grilles.

Ensure that the fan is switched off from the supply mains before removing the guard.

Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest service center.

If the product has been exposed to temperatures below 0°C for some time it should be kept at room temperature for at least 2 hours before turning it on.

The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless such changes influence significantly the product safety, performance, and functions.

Manufacturing date is indicated on the unit and/or on packing as well as in accompanying documents in the following format XX.XXXX where first two figures XX is the month of production, and following four figures XXXX is the year of production.

The device is intended for air circulation in the room.

Place fan basement onto flat horizontal surface. Tighten stand tube to stand base moving it upward and downward and fix it with screws.

Unscrew the blade cap by turning clockwise and rear guard mounting nut by turning counter clockwise. Put rear grille on motor shaft so that two claws on motor cover match two holes on grille and secure with guard nut.

Slide blades on motor shaft so that claws on motor shaft match the blades slots. Screw blade cap on shaft by turning counter clockwise, otherwise the fan will sound abnormal and may be broken while operate.

Put front grill on rear grille and close clips or screw grill ring to secure grilles together.

Do not plug in the device before its assembling is finished.

Do not operate the appliance with damaged blades.

To avoid electroconvulsive shock or fire danger, do not operate fan under the conditions of increased humidity for example do not use it outdoors when it’s raining.

Place fan only onto dry flat unyielding surface.

Switch the fan on by pushing any of the buttons:

1-For minimum operational speed

2-For medium operational speed

To switch the fan off push the button “0”

On the upper part of the motor cover there is oscillating knob. If pressed, it makes the fan cabinet with blades traverse from side to side with the angle 90°. To cancel oscillating mode push oscillating knob upward.

Air flow direction can be changed by adjusting fan control box in a higher or lower position by a vertical adjustment screw.

Before cleaning unplug fan first. Do not use abrasive cleansers, gasoline, solvents or other aggressive detergents

Unfix clips on griſſe or unscrew grille ring and take off front grille. Clean the fan and blades with soft cloth moistened with soap solution.

Keep the device in dry cool place.

It is recommended to to keep and to use for seasonal storage the original carton box of the appliance.

Switch the fan on by pushing any of the buttons:

1-For minimum operational speed

2-For medium operational speed

To switch the fan off push the button “0”

On the upper part of the motor cover there is oscillating knob. If pressed, it makes the fan cabinet with blades traverse from side to side with the angle 90°. To cancel oscillating mode push oscillating knob upward.

Air flow direction can be changed by adjusting fan control box in a higher or lower position by a vertical adjustment screw.

Before cleaning unplug fan first.

Do not use abrasive cleansers, gasoline, solvents or other aggressive detergents

The symbol on the unit, packing materials and/or documentations means used electrical and electronic units should not be toss in the garbage with ordinary household garbage. These units should be pass to special receiving point.

Valid utilization will help to save valuable resources and avoid negative work on the public health and environment which happens with incorrect using garbage.

If the product has been exposed to temperatures below 0°C for some time it should be kept at room temperature for at least 2 hours before turning it on.

Before switching on the appliance for the first time please check if the technical specifications indicated on the unit correspond to the mains parameters.

In case of power cord is damaged, its replacement should be done by the manufacture or service department or the other high-skill person to avoid any danger.

To disconnect the appliance from the power supply pull it out by the plug only, not by the cord.

Avoid contact with moving parts of the device. Do not put pencils or other objects through the protective grid of the fan.

Ensure that the fan is switched off from the supply mains before removing the guard.

Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest service center.