SCARLETT SC-VC80H08 (01) PDF Document

Step 1. Unpack the device.

Step 2. Take the metal stick and insert and connect the metal stick into the opeing.

Step 3. Insert and connect the floor nozzle at the lower opening of the main body of the hand vacuum cleaner.

Connect the plug of the device to the wall power socket.

Press ON/OFF switch to activate the vacuum cleaner. To disactivate it press ON/OFF switch once again.

Use vacuum cleaner without metal stick for cleaning of easy-available surfaces, car, furniture.

To disassemble metal stick from the body of vacuum cleaner, open the clip and pull the stick upward.

The model includes crevice nozzle for removing dust from hard-to-reach places.

To disassemble, remove brush and push crevice nozzle release button for disassemble it.

Filter should be rinsed clean at least twice a year or when it becomes visibly dirty.

Step 1. Grasp the filter assembly from its center and remove the filter from the dust bowl by pulling it on.

Step 2. Rinse the filter under cool tap water and dry it. It is forbidden to dry the filter on radiators or by using other heating devices.

Step 3. Refit the filter into the vacuum cleaner.

Step 4. The filter should be checked regularly for signs of damage preferably after each cleaning.

Do not switch the vacuum cleaner on without refitted filter as it may cause motor damage.

Step 1. Switch off your vacuum cleaner and disconnect the plug of the device from wall socket.

Step 2. Disconnect dust bowl from the vacuum cleaner. Press the dust bowl release button to do it. Empty the dust bowl.

Step 3. The dust bowl can be opened without disassembling the dust bowl from the body of vacuum cleaner. For that press the dust bin lower lid release button. We recomment to empty dust bowl after each usage.

Clean outer surface of the vacuum cleaner body with soft cloth with small amount of detergents which do not contain abrasives. NOTE: It is forbidden to submerge the device and the plug into the water of any flood.

Remove floor brush from the body of the vacuum cleaner by pulling it downward.

Store the vacuum cleaner vertically.

There are special hooks on the handle of device for cord storage.

Before the first use of the appliance check that the voltage indicated on the rating label corresponds to the mains voltage in your home.

To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids.

Do not handle the plug with wet hands. Never switch off the appliance by pulling the cord.

Always unplug the appliance from the power supply when not in use and before servicing.

To avoid voltage overload do not plug the unit and other powerful electrical appliances to the power supply at the same time.

Do not put any object into air outlets. Do not use with outlet blocked. Keep free of dust, hair and anything that may reduce airflow.

Its replacement should be done by the manufacture or service department or the other high-skill person to avoid any danger.

Do not use the appliance outdoors and on wet surfaces.

To avoid deforming of plastic components of the appliance or fire accident, never leave the appliance exposed to direct sun light or near any heater.

Do not let the cord hang over sharp edges or touch hot surfaces.

Never use the vacuum cleaner without filters.

Never use the appliance without dust bin. Replace the dust bin without delay if it is damaged.

Don’t use the vacuum cleaner if the container is filled to the mark “MAX”. When the container is filled, dirty air clogs up the vacuum cleaner filter and the engine can overheat and disable.

Don’t use the vacuum cleaner for cleaning of material debris such as cement, whitewash, plaster, metal shavings and etc. These particles cause to the engine damage.

Don’t wash vacuum cleaner parts in a dishwasher or a construction machine.

Do not use the appliance on wet surfaces. This unit does not absorb water.

If you have cleaned the carpet with liquid detergent, let the carpet dry up completely before vacuuming it.

If the product has been exposed to temperatures below 0°C for some time it should be kept at room temperature for at least 2 hours before turning it on.

Do not attempt to repair, adjust or replace parts in the appliance. Repair the malfunctioning appliance in the nearest service center.

Be careful when cleaning on stairs.

The appliance is not intended for use for physically, sensory or mental disabled person (including children) or for person with lack of life experience or knowledge, if only they are under supervision or have been instructed about the use of the unit by responsible person.

Children must be under control in order not to be allowed to play with the appliance.