ROBUS REXS092-23 (01) PDF Document

Please read the instructions before commencing installation and retain them for future reference. Electrical products can cause death or injury, or damage to property. The installation must be carried out by a qualified electrician.

Note: The luminaire must be disconnected before carrying out any insulation resistance testing.

The ROBUS REXS092-23 is suitable for mounting on a normally flammable surface.

1. Ensure mains supply is switched off before commencing work.

2. Choose the desired location to mount the extrusion, ensuring that the cables are long enough to reach the start of the strip.

3. Remove the diffuser. Place the LED strip inside the aluminium channel and remove the self-adhesive film, press the strip into the channel, and ensure it is secure. Attach the diffuser and end cap, ensuring they are correctly attached.

4. Mark appropriate fixing points for the brackets on the surface. Ensure that the hole does not impinge on joists, pipe work, cables, or other building services.

5. Attach the brackets to the surface using the screws provided.

6. Attach the unit to the brackets.

1. Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with a crossed-out wheelie bin symbol).

2. Please consider your role in contributing to re-use and recycling by returning this product at the end of its life to a collection centre for waste electrical equipment, a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.

3. This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain.

4. The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be disposed of according to local WEEE regulations.