PORODO SOUNDTEC YOTOWAVE PDSTC303 (01) PDF Document

1. On the right earcup, carefully insert the Type-C cable into the Type-C charging port. Connect the other end of the cable to either a computer USB port or a USB-compatible car or wall charger.

2. A solid red LED light will appear to indicate that the headphones are charging.

3. Once charging is complete, the LED light will turn blue.

4. Charging time is approximately 2 hours.

To turn the headphones on, press and hold the power button on the right side of the headphone for approximately 3 seconds until the LED indicator light turns on.

To turn the headphones off, press and hold the power button again for 4 seconds until the LED light turns off.

1. Power on the wireless Bluetooth headphones by following the “Turn It On” instructions.

2. To pair the headphones with a new device, the red and blue LED lights will blink, indicating that the headphones are ready to be paired.

3. On your Bluetooth-enabled smartphone, tablet, or media player, navigate to the Bluetooth settings menu, enable Bluetooth, and search for available devices. After a few seconds, “PD_STC303” should appear in the list of available devices.

4. Select “PD_STC303” to establish the connection. A solid blue LED light will confirm that the device has successfully paired.

5. When Bluetooth is enabled on your previously paired device and it is within range, the headphones will automatically reconnect to the last device they were connected to.

Note: If the headphones are not used for a period of 5 minutes, they will automatically power off to conserve battery.

Power Button Functions:

Power On: Press and hold for 3 seconds.

Power Off: Press and hold for 4 seconds.

Play/Pause, Answer/End Calls: Press once.

Re-dial Last Dialed Phone Number: Double-click.

Reject Incoming Call: Press and hold for 1-2 seconds.

Track and Volume Controls:

Skip to the next track: Press the + area.

Go back to the previous track: Press the – area.

Increase the volume: Press and hold the + area.

Decrease the volume: Press and hold the – area.

Note: All audio, including music, games, videos, and notifications, will be played through the headphones. Proper press gestures and touching the correct areas will ensure a smooth and seamless experience.

If there is no power, recharge your wireless Bluetooth headphones using the provided Type-C cable.

Ensure your Bluetooth device supports the A2DP profile. Confirm that both devices are paired and connected over Bluetooth. Restart the headphones to reconnect your Bluetooth device.

1. Navigate to the Bluetooth settings menu on your Bluetooth device, select “PD_STC303,” and choose “Forget.” Follow the steps to pair your device again.

2. Alternatively, press and hold the power button on the headphones (while powered on) to disconnect the headphones from any previously connected devices. Afterward, follow the steps to reconnect your device.

This product must not be disposed of as unsorted household waste. It is important to separate such waste for proper treatment and recycling, in compliance with local waste management regulations.