Free English PHILIPS DYNALITE DMR316 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD PHILIPS DYNALITE DMR316 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
Who is qualified to install the PHILIPS DYNALITE DMR316?
The PHILIPS DYNALITE DMR316 devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
What are the operating temperature limits for the PHILIPS DYNALITE DMR316?
The operating temperature limits for the PHILIPS DYNALITE DMR316 are from 0° C (32° F) up to 40° C (104° F), with a maximum humidity of ≤90%.
What is the recommended torque setting for connecting wires to the PHILIPS DYNALITE DMR316 terminals?
Refer to the circuit breaker for the torque rating when connecting wires.
What is the maximum conductor size allowed for wiring the PHILIPS DYNALITE DMR316 in step 6 of the installation?
The maximum conductor size allowed is ≤ 16 mm² or 6+ AWG.
What is the recommended torque for the wire termination in step 6 of the PHILIPS DYNALITE DMR316 installation process?
The recommended torque is 1.5 Nm or 13.3 Lb-in.
What are the output ratings per channel for the PHILIPS DYNALITE DMR316?
The output ratings per channel (CH1-CH3) for the PHILIPS DYNALITE DMR316 are:
- Incandescent: 16 A, 277 V~
- Magnetic with Halogen: 16 A, 277 V~
- Electronic Driver: 16 A, 277 V~
- Motor: 12 FLA (2 HP), 230/277V~
What is the inrush current rating for the PHILIPS DYNALITE DMR316?
The inrush current rating for the PHILIPS DYNALITE DMR316 is 500 A.
What is the maximum output rating per group for the PHILIPS DYNALITE DMR316?
The maximum output rating per group for the PHILIPS DYNALITE DMR316 is ≤ 48 A.
What are the supply voltage requirements for the PHILIPS DYNALITE DMR316?
The supply voltage requirements for the PHILIPS DYNALITE DMR316 are:
- Single phase: 120/230/277V~ ± 10% 48 A
- Three phase: 120/230/277V ~ ± 10% 3×16 A
What is the IEC Overvoltage Category for the PHILIPS DYNALITE DMR316 power supply connections?
The IEC Overvoltage Category for the PHILIPS DYNALITE DMR316 is Category III.
What is the torque setting when initially mounting the PHILIPS DYNALITE DMR316 module onto the DIN rail in step 2?
The torque setting for securing the module after mounting is 1 Nm or 8.8 Lb-in.
CLICK HERE TO DOWNLOAD PHILIPS DYNALITE DMR316 (01) PDF DOCUMENT