ONFILTER CLEANSWEEP AV2020NG (01) PDF DOCUMENT

Normally, the ONFILTER CLEANSWEEP AV2020NG requires no maintenance and no calibration. During its normal operation, the filter may have an elevated temperature which would feel “warm” to the touch, but not what is considered “hot.”

If the filter feels “hot” to the touch (more than 60°C or 140°F), turn off the equipment that is powered via the filter immediately. Verify that the total actual current load does not exceed the filter’s maximum rating. Keep in mind that sometimes the power rating of equipment is “typical” rather than “maximum” – it is prudent to load the filter to no more than 75% of its capacity to accommodate for such situations. Check if the heat dissipation of the filter is obstructed by improper installations such as lack of space around it for proper ventilation, or its placement in a small confined space. Rectify the problem. Check within 30 minutes and then within an hour the temperature of the filter. If the filter still feels “hot” to the touch, turn your equipment off, disconnect the filter from the circuit and discontinue using it.

Always observe safety measures when using power line filters. Here are some of the key safety precautions you should take:

Do not exceed filter’s maximum rating – it may cause overheating.

Do not place filter inside a tightly-closed enclosure.

Use filter after the fuse of no more than specified max. rating.

No serviceable parts inside – do not open. High voltage is present inside.

Before attempting any electrical connection, verify that your power source, such as an electrical outlet or junction box, is correctly wired and properly grounded.

Do not use the filter without proper grounding! Failure to properly ground the filter may result in failure to ground your equipment, in an unsafe situation that can cause property damage and injury, as well as failure of the filter to perform.

Proper placement of the filter helps to assure its continuous operation for a long time. Please follow these requirements for installation:

Install filter in a dry location away from debris and from the possibility of spillage, including from floor cleaning.

Ambient temperature at the place of installation should not exceed 5°…40°C range.

Do not install filter in small confined spaces with restricted air circulation in order to avoid overheating. Allow at least 15cm (6″) on each side for proper ventilation.

Follow indicated polarity of the connections as indicated on the filter’s label. The polarity on the connectors is different from each other-do not just swap them. Verify proper polarity before connecting.

We recommend to pull out removable terminal block plugs and make connection first, then insert plugs back in place. Note that the plug polarities are not interchangeable!

Before applying power verify the correct polarity on each terminal block.

You will need a small-blade slot screwdriver, preferably long.

Set the filter so that the top rail fits into the top slot of the enclosure. Gently snap the enclosure on the bottom rail. Don’t force it. In case of any problem, use a slot screwdriver, insert it into the slot in the red latch on the foot of the enclosure and leverage this latch slightly out. The enclosure should install easily.

To remove the filter from the DIN rail, use a flat-head screwdriver, leverage the red latch out, gently pull out the bottom part of the filter away from the DIN rail, lift it slightly, and remove it from the top rail.