MOOGER TRIANGOLO (01) PDF Document

For the MOOGER TRIANGOLO, please connect the designated AC adapter to an AC outlet of the correct voltage. Be sure to use only an AC adapter which supplies 9V DC with a center negative polarity. It is recommended to unplug the AC power adapter when not in use or during electrical storms.

Before connecting or disconnecting your MOOGER TRIANGOLO, always turn off the power of this and all other equipment. This will help prevent malfunction and/or damage to other devices. Also, make sure to disconnect all connection cables and the power cord before moving the unit.

Clean your MOOGER TRIANGOLO only with a soft, dry cloth. If necessary, you may slightly moisten the cloth. Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents, cleaning fluids, or chemical-impregnated wiping cloths.

To avoid deformation, discoloration, or other serious damage to your MOOGER TRIANGOLO, do not expose the unit to the following conditions:

• Direct sunlight

• Magnetic fields

• Excessive dusty or dirty location

• Strong vibrations or shocks

• Heat sources

• Extreme temperature or humidity

• High humidity or moisture

The footswitch on the MOOGER TRIANGOLO engages and disengages the effect. To engage the Tap Tempo functionality, depress the footswitch for more than 2 seconds, which will cause the LED to flash. You can then tap the footswitch two or more times to synchronize the delay to your desired tempo. The pedal will automatically revert back to normal operation after 5 seconds.

The LED on the MOOGER TRIANGOLO displays the on/off status of the pedal. It also provides instant access to Tap Tempo. You can tap the LED 2 or more times to synchronize the delay to your desired tempo.

3. WAVE FORM: Selects between Triangular, Square, and Saw wave forms.

4. SPEED: Adjusts the rate of the tremolo effect.

5. DC IN: Input for a 9V DC regulated power supply.

6. DEPTH: Adjusts the depth and prominence of the tremolo.

7. SUB DIVISION: Selects the sub division rhythm value relative to the tap tempo. X is a random sub-division pattern.

8. Output jack: 1/4″ audio jack for connecting to an amp or other devices.

9. Input jack: 1/4″ audio jack for connecting your instrument or input device.

• High quality digital tremolo

• 3 selectable wave forms

• Tap tempo functionality

• 5 different sub division values

• Full metal housing

• True bypass switching

Modes: Tremolo effects with tap tempo functionality.

Input: 1/4″ mono audio jack. (Impedance: 470k Ohms)

Output: 1/4″ mono audio jack (Impedance: 100 Ohms)

Power requirements: AC adapter 9V DC, center negative. Highly recommend to use Mooer Micro Power.

Current Draw: 160mA

Dimensions: 93.5mm(D) x 42mm(W) x 52mm(H)

Weight: 146g

Accessories: Owner’s Manual