MIDEA MER30S2AWW (01) PDF Document

Free English MIDEA MER30S2AWW (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.

CLICK HERE TO DOWNLOAD MIDEA MER30S2AWW (01) PDF DOCUMENT

If this is not the document you want for this product, click here to see if we have any other documents for this product.

How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.

How do I verify the anti-tip device is properly installed on my MIDEA MER30S2AWW?

To confirm the anti-tip bracket is properly installed on the MIDEA MER30S2AWW, look underneath the range to confirm the rear leveling leg is engaged in the bracket. If a visual inspection is not possible, follow these steps:

1. Slide the range forward.

2. Confirm the anti-tip bracket is securely attached to the floor or wall in the correct position according to the installation instructions.

3. Fully slide the range back against the wall so that the leveling leg engages with the anti-tip bracket.

How do I remove the oven door on the MIDEA MER30S2AWW for cleaning or installation?

The door of the MIDEA MER30S2AWW can be removed to make the appliance lighter and the oven cavity more accessible during installation or cleaning:

1. Open the door fully.

2. On each door hinge, flip down the lock mechanism so that it engages with the door when the door is rotated towards being closed.

3. Once both lock mechanisms are engaged, continue to rotate the door until it is approximately 2 to 3 inches from being fully closed.

4. Grasp the door firmly from the sides and lift the door up and out from the oven face. Do not lift the door by the handle to reduce the risk of broken door glass.

How do I reinstall the oven door on my MIDEA MER30S2AWW?

To reinstall the door on the MIDEA MER30S2AWW, follow these steps:

1. Holding the door from the sides, align the door so that the hinges slip back into the openings.

2. Rotate the door until it is 2 to 3 inches from being fully closed, allowing the door to drop into the notches on the hinges.

3. Rotate the door out until it is fully open.

4. Flip the hinge locking mechanism back up and away from the door.

5. Check that the door opens and closes correctly.

6. If the door does not operate correctly, re-engage the locking mechanisms, remove the door, and reattempt the installation.

How do I remove and reinstall the storage drawer on the MIDEA MER30S2AWW?

To remove the drawer: Fully extend the drawer until it cannot be pulled out further, raise the drawer panel up, and then pull the drawer out.

To reinstall the drawer: Align the rails on the drawer with the slides on the range and push the drawer in. Open and close the drawer to ensure the slide rails are operating properly.

How do I level the MIDEA MER30S2AWW?

1. Use a tape measure to measure from the floor to the top of the countertop at all four corners of the installation space.

2. While the range is still positioned outside the installation space, adjust the leveling leg at each corner so that the distance from the floor to the underside of the cooktop edge matches the dimensions measured in the installation space.

3. Move the range into its final location using two people, being careful not to damage the floor or cabinetry.

4. Confirm the range is level by placing a level on the center rack position. Check the level both front-to-back and side-to-side. Use adjustable pliers to adjust the leveling legs as necessary.

How do I test the cooktop and oven operation on the MIDEA MER30S2AWW after installation?

For Cooktop Operation:

1. For each burner, rotate the knob to the HI position and confirm the element begins to glow and heat up.

2. Confirm the hot surface indicator light illuminates correctly.

For Oven Operation:

1. Ensure the door is closed, all packaging is removed, and the oven is empty except for the racks.

2. Press the BAKE button; the control will default to 350 degrees Fahrenheit.

3. Adjust the temperature setting to 170 degrees Fahrenheit and press the START/ENTER button.

4. Listen for relays to click. After a couple of minutes, confirm heat can be felt radiating from the oven bottom without touching it.

5. Allow the mode to run until the display shows PRE and signals the temperature is reached. Press CLEAR/OFF.

6. Press the BROIL button and then START/ENTER. After a few minutes, confirm heat is radiating from the broil element and it begins to glow red. Press CLEAR/OFF.

What are the troubleshooting steps for the MIDEA MER30S2AWW cooktop?

Problem	Possible Reason
Unable to maintain a rolling boil or will not cook fast enough.	Improper cookware – Only use pans with flat bottoms that match the diameter of the heating element. Cover pans with a lid to retain heat.
Cooktop will not operate.	Check if the control panel is lit. If not, check the circuit breaker or fuse and ensure the power cord is plugged in properly.
Cooktop heating element does not glow steadily.	This is normal. The element cycles on and off to maintain the selected power level, even on the highest setting.
Cooktop glass is scratched.	Incorrect cleaning method or use of cookware with rough bottoms. Scratches cannot be removed, but future damage can be avoided by using flat-bottomed, smooth, clean cookware.
Cooktop is discolored.	The cooktop is not being cleaned thoroughly.
Cooktop is pitted.	A sugary spill occurred on hot glass. This cannot be repaired and requires glass replacement.

What are the troubleshooting steps for the MIDEA MER30S2AWW oven?

Problem	Possible Reason
Strong burning or oily odor when using a new oven.	This is normal and will disappear after a few uses. Ensure all packaging materials were removed.
Control is dark and will not respond.	The control may be in Sabbath Mode. Check the display for symbols like ] or ] [.
Control is lit but will not respond.	Check if the CONTROL LOCK has been activated.
Food is not baking evenly.	Ensure you are using recommended rack settings. Moving food down one position makes the bottom darker; moving it up makes the top darker.
Smoke or steam comes from the back of the cooktop.	It is normal for steam to be released from the oven vent. If it smells like burning food, check for spills inside the oven.
An E and a number appears in the display.	This is an error code. Press CLEAR/OFF to stop the beeping. If it persists, reset the power by cycling the circuit breaker off and then on.