LOGITECH TOUCHPAD T650 (01) PDF Document

Step 1. Plug the Unifying receiver into a USB port on your computer.

Step 2. Move the power switch on the touchpad to the On position. Check the battery status light. A red light means it’s time to charge the battery.

Step 3. You may be prompted to install Logitech software. This software enhances your touchpad experience with additional gestures, smoother performance, and personalized settings. Follow the onscreen instructions to complete the installation.

Connect the LOGITECH TOUCHPAD T650 to your computer using the supplied Micro-USB charging cable. The status light blinks green while charging. Charge your touchpad until the status light stops blinking. A full charge powers your touchpad for about a month. A blinking red light on the status indicator means it’s time to recharge the battery.

Click (left-click): Press the touchpad surface.

Right-click: Press the lower-right corner of the pad.

Scroll: Swipe two fingers up, down, or sideways.

Swipe a single finger from one of the touchpad edges to perform Windows 8 shortcuts:

Swipe from the left edge: Cycle through open applications.

Swipe from the right edge: Display the charms bar.

Swipe from the top edge: Display the application bar.

Swipe with three fingers to navigate within Windows:

In Windows 8:

Swipe up to return to Windows 8 Start.

Swipe left or right for back and forward.

Swipe down for the desktop.

In Windows 7 (with software installed):

Swiping up launches the application switcher.

The Logitech software enables additional gestures. If you have not installed it, you can download it from the Logitech website.

Control windows:

Swipe four fingers to resize or relocate the active window.

Swipe up or down to maximize or minimize the window.

Swipe left or right to snap the window to the corresponding edge of the screen.

Zoom:

Pinch with two fingers to zoom in or out.

Logitech Unifying technology connects up to six compatible Logitech mice and keyboards to the same receiver, using only one USB port for multiple devices.

If your LOGITECH TOUCHPAD T650 is not working, try the following troubleshooting steps:

Restart the Touchpad by turning it off and then back on.

Check the Unifying receiver connection.

Move the Unifying receiver to another USB port on your computer. Try connecting directly to your computer instead of using a USB hub.

Remove any metallic objects near the Touchpad.

If the status light blinks red, recharge the battery.

If you are having problems with gestures, avoid resting unused fingers or your palm on the touch surface.

To dispose of the battery, follow these steps:

Step 1. Remove the plastic label on the Touchpad base.

Step 2. Remove the four screws from the bottom case.

Step 3. Unplug the battery and take it out of the case.

Step 4. Dispose of the battery and product according to local laws.