LELO BILLY2 (01) PDF MANUAL

LELO BILLY2 (01) PDF SUMMARY:

How do I unlock BILLY 2?

Unlock by pressing and holding the + and – buttons together for 3 seconds until the light turns on.

How do I use BILLY 2?

• Press the + button to turn on; press again to increase the vibration strength.
• Press the ▲ and ▼ buttons to switch between the 8 vibration patterns.
• Press the – button to reduce vibration strength.
• Press and hold the – button to turn off.

How should I hold BILLY 2?

Tip: For an even more pleasurable sensation, apply a liberal amount of LELO Personal Moisturizer to your body and to BILLY 2 before and during use.

How do I charge my BILLY 2?

• Insert the DC plug into the DC port at the base of your BILLY 2.
• Insert the mains plug into a wall socket. The LED on the interface of your BILLY 2 will pulse to indicate it is charging. When it is fully charged (after c. 2 hours), the LED will emit a steady glow.
• When the battery is running low, the LED on your BILLY 2 will emit a blinking white light.
• Only use original chargers provided by LELO with your BILLY 2.

How do I clean BILLY 2?

• BILLY 2 is fully waterproof, making cleaning simple. Rinse and spray with LELO Toy Cleaner, then rinse again and allow to dry.
• Always clean your BILLY 2 thoroughly before and after each use. You can wash the silicone with warm water and antibacterial soap, rinse with clean hot water and pat dry with a lint-free cloth or towel. Never use cleansers containing alcohol, petrol or acetone.

What should I avoid when storing BILLY 2?

• Avoid leaving your BILLY 2 in direct sunlight and NEVER expose it to extreme heat.
• Store your BILLY 2 in a dust-free place and keep it away from products of other materials.

What do I do if the LED on BILLY 2 does not pulse when the charger is connected?

• The battery is drained and will require several minutes to acknowledge that it is being charged.
• The charger is not properly connected. Check wall and DC sockets.

What do I do if BILLY 2 does not activate when the center button is pressed?

• The battery is empty. Recharge your BILLY 2.
• The interface of your BILLY 2 is locked. Hold down + and – for 5 seconds.

How do I activate the 1-Year Limited Warranty?

To activate your 1-Year Limited Warranty, register the number provided on the LELO Authenticity Card at LELO.COM/SUPPORT.

How do I claim my warranty?

To claim your warranty, you must log in to your account at LELO.COM then select the option to make a warranty claim. Shipping costs are non-refundable.