LEGRAND SANUS MEGTS1-W2 (01) PDF Document

Be aware of pinch points. The instruction manual highlights several areas on the tilt stand’s joints and hinges where fingers could be pinched. Exercise caution when folding, unfolding, or adjusting the stand to avoid injury.

Please follow these steps to assemble your LEGRAND SANUS MEGTS1-W2:

Step 1. Attach the included cover to the base of the stand. It should snap into place.

Step 2. Route the Echo Hub’s power cable through the opening at the back of the stand’s base.

Step 3. Secure the power cable by weaving it through the cable management clips on the stand. Plug the cable into the port on the stand.

Step 4. Align the mounting bracket of the stand with the corresponding slot on the back of the Echo Hub. Slide the stand upwards until it clicks securely into place.

Step 5. Wrap any excess cable around the cable management hooks located on the arm of the stand.

Step 6. Attach the final cover over the wrapped cable on the back of the stand’s arm.

To adjust the viewing angle, hold the base of the LEGRAND SANUS MEGTS1-W2 stand with one hand and gently push or pull the top of the Echo Hub with your other hand. You can tilt it forwards or backwards to achieve your desired viewing angle.