KUSSMAUL AUTO CHARGE 12VHO 091-12VHO-36-230 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Click here to download KUSSMAUL AUTO CHARGE 12VHO 091-12VHO-36-230 (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** BOOK# -12VHO-2 REV: 10-11-2002 INs-rnucT10N MANUAL AUTO CHARGE 1 evH0 AUTOMATIC BATTERY CHARGER MODEL #091-1 evH0-xx NOTE : This charger is designed for vehicles with a single battery system a YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC. 1 70 CHERRY AVE. , WEST SAYVILLE, N.Y. 1 1 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826

****** Page 2 ****** INTRODUCTION The Auto Charge 12VHO is Battery Charger is a compact completely automatic charger designed for installation on vehicles with a single battery system. Remote sensing permits long lines between the charger and the batteries by compensating for the voltage drop in the charging wires. An ammeter provides continuous indication of the charger output. Construction of the Auto Charge 12VHO is extremely rugged to withstand the shock and vibration normally encountered by vehicle mounted equipment. The unit operates com- pletely automatically and stops charging the batteries when they are fully charged. There is no trickle charge and therefore no danger of overcharging and water boil-off. Any parasitic loads on the battery such as radio, lights, etc., are automatically supplied with current by the charger. INSTALLATION The Auto Charge 12VHO Automatic Battery Charger should be installed in an area with adequate ventilation. A power cord is supplied for connection to A.C. 1 . Mount the charger using the four holes provided for this. 2. Connect the wiring from the battery to the Output Terminal Strip. Strip the wire insulation approximately 3/8″. 3. Double check all wiring before proceeding. 5. Wire the A.C. power. 6. Pilot light will light to show that the charger has power.

****** Page 3 ****** INSTALLATION WIRING DIAGRAM AUTO CHARGE D.C. AMPERES VHO POWER O FUSE 15 AMP , rusr. BATTERY SENSE 000000 nnoonne CHART CONNECTION BAT- BAT+ SENSE SENSE ITEM BATTERY NEGATIVE BATTERY POSITIVE NEGATIVE SENSE POSITIVE SENSE DEFINITION NEGATIVE CHARGING LEAD FOR BATTERIES POSITIVE CHARGING LEAD FOR BATTERY # 1 NEGATIVE VOLTAGE SENSE LEAD. DETECTS VOLTAGE POSITIVE VOLTAGE SENSE LEAD. DETECTS VOLTAGE WIRE SIZE 10 AWG 10 AWG 16 AWG 16 AWG IMPORTANT: Each lead wire shall not be greater than 20 feet for the charger to deliver the full 20 amp output. If wiring is to be longer, consult the factory for addi- tional information. NOTE: The sense leads must be connected to the battery system as shown for the charger to operate. A simple check can be made as follows see example: EXAMPLE: Assuming a 24 VDC battery system, the positive sense lead must read approximately +24 VDC with respect to the negative sense lead at the charger. The battery “+1′ terminal must read approximately +24 VDC with respect to the battery terminal at the charger. These measurements shall be made before the AC power to the charger is applied.

****** Page 4 ****** SPECIFICATION e OUTLINE 230 volt, 60 Hz., 230 volt, 60 1-Iz., 230 volt, 60 Hz., 230 volt, 60 Hz., 230 volt, 60 Hz., 230 volt, 60 1-Iz., 230 volt, 60 Hz., 230 volt, 60 1-Iz., 230 volt, 60 Hz., SPECIFICATIONS: Input: See Chart Output: See Chart Output Current: See Chart Charge Indicator: D.C. Ammeter Weight: 22 lbs MODEL 091-12VHO-24 091-12VHO-32 091-12VHO-36 091-12VHO-48 091-12VHO-64 091-12VHO-72 091-12VHO-84 091-12VHO-96 091-12VHO-120 091-12VHO-24-230 091-12VHO-32-230 091-12VHO-36-230 091-12VHO-48-230 091-12VHO-64-230 091-12VHO-72-230 091-12VHO-84-230 091-12VHO-96-230 091-12VHO-120-230 AMPS VOLTAGE 20 15 13.3 10 7.5 6.6 5 5 4 20 15 13.3 10 7.5 6.6 5 5 4 24 Wlts 32 volts 36 xolts 48 Wlts 64 xolts 72 volts 84 wits 96 Wlts 120 24 ‘volts 32 Wlts 36 ‘volts 48 xolts 64 Wlts 72 volts 84 Wlts 96 Wlts 120 volts INPUT 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 120 volt, 60 Hz, 10 Amps 10 Amps 10 Amps 10 Amps 10 Amps 10 Amps 10 Amps 10 Amps 10 Amps 4 Amps 4 Amps 4 Amps 4 Amps 4 Amps 4 Amps 4 Amps 4 Amps 4 Amps 9/32″ DIA. 4 HO ES 4.8 5.3 Outline Dimensions, 1 2.6 13.2 AUTO CHARGE 12 VHO

****** Page 5 ****** INSTALI-ATION Date Installed Installed By Vehicle Identification Vehicle Owner RECORD e WARRANTY WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid. Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and [or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.