KUSSMAUL 091-145HO-12 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Click here to download KUSSMAUL 091-145HO-12 (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** INPUT: 120 Volte, 50/60 Hz AC OUTPUT 1 : 12 Volts, DC, Isolated OUTPUT 2: 12 Volts, DC, Isolated a YEAR WARRANTY m KUSSMAUL ELECTRONICS CO., INC 1 70 CHERRY AVE. , WEST SAYVILLE, N.Y. 1 796 FILE: -1 DATE: 02-04-09 INSTRUCTION MANUAL DUAL- volt-æo Amp AUTOMATIC BATTERY CHARGER FAX: 631-567-5826 MODEL # 091-145140-12 1 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857

****** Page 2 ****** INTRODUCTION The Auto Charge Dual 1 2 volt-20 amp. Battery Charger is a compact, completely automatic charger designed specifically for installations that require 24 volts for starting and 1 2 volts for accessories. The two batteries are connected in series to obtain 24 volts and the output of each charger is connected to each battery. Each output of the charger is individually controlled to charge it’s particular battery and is electrically isolated from the other. Two separate ammeters indicate the output current to each battery. Construction of the Auto Charge Dual 1 2 volt-20 amp Battery Charger is extremely rugged to withstand the shock and vibration encountered in vehicle mounted equipment. Each output operates completely automatically and stops charging its battery when the battery is fully charged. There is no trickle charge, and therefore no danger of overcharging and water boil-off. Any parasitic loads on the batteries such as radios, lights, etc., are automatically supplied by the respective charger output. 2

****** Page 3 ****** INSTALLATION The Auto Charge Dual 1 2 Volt-20 amp Automatic Battery Charger should be installed in an area with adequate ventilation. Wiring is illustrated in figure 1 and figure 2. 1 . Mount the charger using the four holes provided for this. 2. Connect the wiring from the batteries to the Output Terminal Strip. 3. Double- check all wiring before proceeding. 4. Connect the A.C. power through the provided line cord (attached to the charger). 5. Pilot light will show that the charger has power. Figure 2 illustrates this charger connected to two batteries in series. Each battery is individually charged and charging ceases automatically when that battery is fully charged. Thus if battery 1 requires more charging due to the accessory load, charging to battery 1 will continue even after the charger has stopped charging battery 2. This ensures that both batteries will be fully charged but neither will be over-charged. 3

****** Page 4 ****** INSTALLATION 2 INDIVIDUAL BATTERIES AWG WIRE TO CHARGER BATTERY 1 BATTERY 2 MMM voltd Figure 1 POWER FUSE 115 Volts, A.C. olt 4

****** Page 5 ****** INSTALLATION 24 Volt Starter, 12 Volt Accessories BATTERY 1 BATTERY 2 MååM AWG WIRE TO CHARGER volt 12 VOLT ACCESSORIES POWER FUSE volte 115 Volts, A.C. TO STARTER & THER 24 Volt CIRCUITS BATTERIES CONNECTED IN SERIES NOTE: THE SERIES CONNECTION OF THE TWO 12 VOLT BATTERIES PRODUCES 24 VOLTS. EACH BATTERY IS INDIVIDUALLY CHARGEDAT 12 VOLTS. THUS, EVEN THOUGH THE BATTERIES MAY SUPPLY DIFFERENT LOADS, EACH BATTERY IS AUTOMATICALLY SUPPLIED WITH THE CORRECT CHARGING CURRENT. WHEN EACH OF THE BATTERIES IS FULLY CHARGED IT’S CHARGER STOPS CHARGING. Figure 2 5

****** Page 6 ****** SPECIFICATIONS Input Voltage: 115 VAC, 50/60 Hertz Input Fuse: 15 Amperes (normal blow) Input Current: 8 Amperes A.C. Output Voltage: Dual 12-volt outputs e OUTLINE Output Current: 20 Amperes D.C. per output Charge Indicators: 0 to 25 Amperes per output Weight: 22 lbs 9/321 4,75 7.00 1325 5.25

****** Page 7 ****** INSTALLATION RECORD e WARRANTY Date Installed Installed By Vehicle Identification Vehicle Owner WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid. Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. 7


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.